Agri-Fab 45-02942-131 Manual Del Usuario página 5

8. Tighten the bolts and nuts assembled in figure 3.
Tighten the bolts and nuts assembled in figure 1.
Tighten the rear bolts and nuts assembled in figure 2.
9. Assemble the axle bracket to the outside of the rear
angle brackets using two 5/16" x 1" hex bolts (D) and
5/16" nylock nuts (I). The angled ends of the axle bracket
must point as shown in figure 4. Tighten the bolts and
nuts and then loosen slightly.
5/16" NYLOCK NUT
FIGURE 4
10. Assemble the wheels to the axle bracket using two
shoulder bolts (A) and two 3/8" nylock nuts (H). Tighten.
See figure 5.
SHOULDER BOLT
3/8" NYLOCK NUT
FIGURE 5
ENGLISH
AXLE BRACKET
5/16" x 1"
HEX BOLT
11. Assemble a hitch arm mount bracket to the axle bracket
using two 5/16" x 1" carriage bolts (E), and 5/16" nylock
nuts (I). Do not tighten yet. See figure 6.
12. Insert the lift handle down through the tine shield. At-
tach it to the just assembled hitch arm mount bracket
using a 5/16" x 1" hex bolt (D) and a 5/16" nylock nut
(I). Tighten. See figure 6.
13. Position the hitch arm mount bracket so that there is
side tension on the lift handle when it is locked in the
up position. Tighten the nuts. See figure 6.
14. Assemble the grip (K) onto the end of the lift handle.
See figure 6.
FIGURE 6
5
GRIP
LIFT HANDLE
5/16" x 1"
CARRIAGE BOLT
5/16" x 1"
HEX BOLT
5/16" NYLOCK
5/16"
NUT
NYLOCK
NUT