Assembly; Operation - Ryobi ONE+ P724 Manual Del Operador

WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
APPLICATIONS
You may use this product for the following purpose:
 Light-duty vacuuming of dry surfaces
 Household type
INSTALLING/REMOVING BATTERY PACK
See Figures 1 - 2, page 8.
 Place the battery pack in the stick vacuum. Align the
raised rib on the battery pack with groove in stick
vacuum's battery port.
 Make sure the latches on each side of the battery pack
snap into place and that the battery pack is secured in
the stick vacuum before beginning operation.

ASSEMBLY

WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.

OPERATION

 Locate the latches on the side of the battery pack and
depress both sides to release the battery pack from the
stick vacuum.
NOTE: It is not necessary to remove the battery pack from
the tool to recharge.
 With the battery installed, place the tool on the wall-
mounted charger by aligning the raised ribs on the tool
housing with the grooves on the charger.
 Slide the tool down until it is fully seated on the charger.
NOTE: The green LED indicator will flash quickly to evaluate,
intermittently while charging, and will fade in and out when
fully charged.
STARTING/STOPPING THE VACUUM
See Figure 3, page 8.
To start the vacuum:
 Press the ON/OFF trigger once to start the vacuum and
the LED indicator illuminates blue.
To stop the vacuum:
 Press the ON/OFF trigger again.
HIGH/LOW SWITCH
See Figure 3, page 8.
The vacuum has two speeds to accommodate your cleaning
needs.
NOTE: The vacuum always starts in high speed.
 Press the ON/OFF trigger once to start the vacuum in
HIGH speed and the LED indicator illuminates blue.
 Press the HIGH/LOW switch for LOW speed and the LED
indicator illuminates green.
NOTE: Pressing the HIGH/LOW/ switch repeatedly will toggle
the vacuum between the two speeds.
5 — English