Publicidad
Idiomas disponibles
Idiomas disponibles
Bathtub Leveling
The self-supporting metal structure does
not
require
masonry
bathroom can already be finished with the floor
and wall covering.
This structure has several leveling feet,
through which the bathtub is leveled. For this,
turn it clockwise or counterclockwise (figs. 7 and
8).
7
8
24
installation,
so
the
5 Use
Heater
9
5
1
2
A) By pressing button 1, the digital panel (5) will
light up and show the water temperature.
B) Button 2 consists of two arrows, up and
down, used to program the desired tempe-
rature, between 20 and 40 °C.
By pressing these buttons, the panel stops
showing the water temperature and starts
showing the programming temperature, after
finishing programming, the panel goes back
to showing the water temperature.
C) Button 3 turns on the whirlpool.
D) The red LED (4) shows the heating operation.
The heater turns on automatically when pro-
gramming a higher temperature than the
water, with a maximum limit of 40°C, and
turns off when the programmed temperature
is reached.
The heater is equipped with a level sensor,
which prevents the hydromassage and the
heating from being activated without the proper
water level in the bathtub, thus avoiding
possible damage to the equipment.
The ideal water level is covering all hydro-
massage jets.
4
3
Publicidad
