Klarstein KINGSVILLE SMOKER Manual De Instrucciones página 33

• Choose a suitable place to set up the device. Place the device on a fl at, suffi ciently
large surface where it is stable. Make sure the inlet and outlet regulators are correct
and suitable for the gas cylinder valve and the device.
• If the regulator is used outdoors, make sure it is protected from the elements.
• You will need a suitable spanner to connect the gas bottle.
• When connecting the hose, make sure it is not twisted.
Connecting and changing the gas cylinder
• Carry out the changing of the gas cylinder away from any source of ignition.
Position the gas bottle on the left side of your gas grill, it should not be placed
inside the grill. Note that the gas cylinder must be protected from heat and kept in a
safe position.
• When your gas grill is ready to use, insert the regulator into the gas cylinder valve
and tighten securely.
WARNING
Risk of injury and damage to property! Before attempting to light your
gas grill, read and understand all instructions, warnings, and safety
precautions outlined in this owner's manual.
• Check the hose for cracks, cuts or abrasions before each use. If the hose is
damaged in any way, do not use your gas grill.
• When changing the gas bottle, make sure that there are no sources of ignition
nearby, e.g. fi re, cigarettes, open fl ames, etc. Make sure the device is turned off.
• The device may only be used with liquid gas cylinders in accordance with the
information in the "Technical Data" section and the gas label shown in these
instructions. The gas cylinder used must comply with national regulations.
EN
33