Publicidad
Idiomas disponibles
Idiomas disponibles
If you continue to use the device after the sewage exceeds the maximum water level, the floating ball will
move up and the suction will stop.
Remove the wastewater tank. Open the cover of the tank and pour away the waste water.
Clean the tank, the upper cover and the sealing strip. Clean it right after use to avoid bacteria
development and bad smell.
Reinstall the sealing strip, replace the cover and fasten the wastewater tank on the device.
Cleaning accessories:
After each use, disassemble the head part by pressing the button and pulling out the head.
Disassemble the brush cover by opening it with your fingers and then remove it. Clean the brush and
empty the nozzle if blocked.
To reinstall it, make sure the pin and hole fit well, then press on in until you heard a clicking sound.
Check the hose for breakage and leakage.
Rinse all the sponge filters after use and replace them if they are damaged.
If water flows into the device, turn it off and clear away the water inside the device, pipe and tank.
Let the device dry before starting it again.
Problems
The machine does not
work after the switch is
turned on.
When the watering
button is pressed,
there is no water or
little water
There is no dust
collection or the
suction is very weak.
Correct disposal of the unit (Electrical and Electronic Equipment).
(Applicable in the European Union and the rest of Europe that have adopted separate collection
systems countries). The European Directive 2012/19/EU on Waste Electrical and Electronic Equipment
(WEEE), requires that old household electrical appliances must not be disposed of in the normal
household waste stream. Old appliances must be collected separately in order to optimize the
recovery and recycling of the materials they contain and reduce the impact on human health and
the environment. The symbol of the crossed out dustbin is marked on all products to remind the
obligations of separate collection. Consumers should contact their local authority or retailer for
information concerning the correct disposal of their product.
•
Non contractual illustration
•
Product information is subject to change without prior notice.
----------------------------------------------------------------------------------------------
Gracias por haber elegido un producto Livoo!
Figure 7
Causes
The plug is not properly connected and
loose, resulting in poor contact.
Power cord is broken. The machine set
overheats and the protective device operates
The nozzle is blocked.
The handle or the pump is damaged.
The waste water tank is full, causing the
floating ball to work.
The hose is abnormal.
The wastewater tank is not installed in place.
The inlet air sponge is blocked
www.livoo.fr
Solutions
Turn off the power and plug it again.
Call the after sales service.
Remove the brush and rinse the nozzle
with clean water.
Clean up the sewage and use it again.
Check the hose for cracks, breaks and
clogs.
Install the waste water tank properly.
Clean or replace the sponge.
ES
Publicidad
