Ubbink SolarMax 2500 Instrucciones De Uso página 3

Operating Manual – SolarMax 2500
1
Installation and commissioning
1. Completely unroll the pump connecting cable.
2. Screw the adapter for the extension pipe on to the pump outlet.
3. Connect the appropriate number of extension pipes and attach the selected fountain jet. Attach the extension pipe and pipe adapter to the pump..
Vulkan: Make sure the spray head is not positioned too far above the water surface to
maximise the height of the Vulkan fountain.
Water bell: The jet attachment should be placed well above the water surface.
The size of the water bell can be adjusted by pressing down or lifting up the top
part of the jet. The larger the gap for the water outlet, the smaller the water bell.
Bubbler jet: Make sure that the six deflector openings of the spray head are
always under water.
4. Place the pump in the pond. Avoid a position directly on the bottom of the pond,
because here the pump will suck in a lot of dirt and become quickly soiled.
5. Put together the solar module retainer (pipes and earth spike) and then attach it to the
back of the module.
6. Connect the pump plug to the solar module jack and tighten the retaining ring.
7. Place the solar module in a sunny, shadow-free place.
8. Ensure that the solar pump is always fully submerged in water.
9. The SolarMax 2500 fountain set is now ready for operation.
Note:
The pump has a built-in dry running protection function. Two sensor points are provided
on one side of the pump body (not visible from the outside). If one or both of the sensor
points is not under the water, the pump will stop working.
Caution! The plug connector is protected from inverse polarity,
so do not use force when plugging them in.
3