Publicidad
Idiomas disponibles
Idiomas disponibles
Place the cap over the battery pack and push down until
the cap meets the threads at the end of the tool.
Screw the cap on securely.
NOTE: Do not attempt to use this product if the battery
cap is not securely closed.
To remove:
Unscrew and remove the battery cap.
Remove the battery pack from the tool.
LED LIGHT FUNCTIONS
See Figure 1, page 9.
When a charged battery pack is installed in the tool, the LED
light will indicate the status of the battery.
BATTERY STATUS
Charged
Low Battery (5- 25%)
Low Battery (0- 5%)
Overload Protection
High Temperature Protection
OVERLOAD PROTECTION
When the tool is forced or the motor is overloaded, the tool
will automatically shut off. To reset the tool, wait 5 seconds,
slide the on/off switch to the OFF position and then slide it
to the ON position to resume operation. If the tool still does
not resume operation, remove and reinsert the battery. Do
not force the tool.
HIGH TEMPERATURE PROTECTION
This tool is equipped with a high temperature protection
feature that automatically deactivates the tool when it is
overheated. To resume operation, allow the tool to cool and
then turn the tool on.
INSTALLING/REMOVING ACCESSORIES
See Figures 2 - 3, pages 9
To install:
Remove the battery pack from the tool.
Choose an accessory that fits the collet and is suitable
for the application you are attempting.
Using your hand, rotate the clamp nut counterclockwise
to loosen.
OPERATION
LED LIGHT SCENARIO
Solid Green
Solid Red
Flashing Red (3 Flashes)
Flashing Red (6 Flashes)
Flashing Red (9 Flashes)
7 - English
NOTE: If desired, the nut can be loosened with a
wrench. Place the wrench on the nut securely and turn
counterclockwise to loosen.
Insert the shank of the blade accessory into the center
of the clamp nut until the shank is secure.
Rotate the clamp nut clockwise until the blade is secure.
Avoid excess tightening of the clamp nut
NOTE: If desired, the clamp nut can be tightened with a
wrench. Place the wrench on the hexed area of the nut
and turn clockwise to tighten.
To remove:
Remove the battery pack from the tool.
Loosen the clamp nut.
Remove the accessory.
DANGER:
If you are changing an accessory immediately after use,
be careful not to touch the collet or the accessory with
your hands or fingers. You will get burned because of
the heat build-up from operation. Always use the wrench
provided or allow the collet to cool.
TURNING THE POWER CARVER ON/OFF
See Figure 4, page 9.
To turn the power carver ON, slide the on/off switch to the
ON position. To turn it OFF, slide the on/off switch to the
OFF position.
OPERATING THE POWER CARVER
See Figures 5 - 6, page 10.
Learning to use the power carver:
Hold the tool in your hand and get used to its weight,
balance, and the taper of the housing. This taper permits
the tool to be grasped like a pencil or in a "golf grip"
method.
Examine the power carver accessories carefully. Damaged
accessories can fly apart as they come up to speed and
should not be used. The use of damaged accessories
can result in serious personal injury.
Practice on scrap materials first to see how the tool
operates. Keep in mind that the work is done by the speed
of the tool and by the accessory in the collet. You should
not lean on or push the tool into the work.
Publicidad
