Publicidad
Idiomas disponibles
Idiomas disponibles
Replacing the lamp
DANGER TO LIFE! Only install the lamp with the device switched off! Unplug from mains before!
CAUTION! The lamp has to be replaced when it is damaged or thermally deformed due to the heat!
The lens must be replaced if it is visibly damaged and therefore operating with reduced efficiency.
Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 5 minutes).
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp
manufacturer's notes!
Do not install lamps with a higher wattage! Lamps with a
higher wattage generate temperatures the device was not
designed for. Damages caused by non-observance are not
subject to warranty.
For the installation, you need one GX9.5 halogen lamp up to
max. 1000 W
Procedure:
Step 1: Open the Service Lid on the bottom of the device
by unscrew the two screws.
Step 2: Pull of the lamp holder
Step 3: Remove the old lamp.
Step 4: Install a same type lamp into the lamp-socket,
fasten the two screws by hands.
Step 5: Close the Service Lid and screw the 2 screws.
Installing
The installation of the device has to be built and constructed in a way that it can hold 10 times the
weight for 1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch
net. This secondary safety attachment must be constructed in a way that
no part of the installation can fall down if the main attachment fails.
Caution: Devices may cause severe injuries when crashing down! If you
have doubts concerning the safety of a possible installation, do NOT
install the device!
DANGER OF FIRE! When installing the device, make sure there is no
highly inflammable material (decoration articles, etc.) within a distance of
min. 0.5 M.
Mount the device with the mounting-bracket to your standing system. The
hole in the mounting bracket has a diameter of 13 mm.
Adjust the desired inclination-angle via the mounting-bracket and fix
the fixation screws.
DANGER TO LIFE! Before taking into operation for the first time, the
installation has to be approved by an expert or by qualified
ENGINEERS/TECHNICIANS only!
Connection with the mains
DANGER TO LIFE! The electric connection must only be carried out by a qualified electrician!
In order to connect the device to the mains, you have to install a power-plug.
The occupation of the connection-cables is as follows:
The earth has to be connected!
Connect the device to the mains with the power-plug.
If the device will be directly connected with the local power supply network, a disconnection switch with
a minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
MOON 1000
Cable
Pin
Brown
Live
Blue
Neutral N
Yellow/Green Earth
USER MANUAL/MANUAL DE USO
International
L
PAGE/PAGINA 2
EN
Publicidad
