Sharp PN-L862B Manual De Instalación página 13

Model
PN-L862B
Power requirement
AC 100 - 240 V, 5.3 A,
50/60 Hz
Operating temperature * 41°F to 95°F (5°C to 35°C)
1
Operating humidity 20% to 80% (no condensation)
Power consumption
470W
Dimensions inch (mm)
Approx. 77-1/16 (W) x 3-3/8
(excluding protrusions)
(D) x 45-5/8 (H) (1957 x 85.7 x
1159.5)
Weight lbs. (kg) Approx. 137.8 (62.5)
*1 Temperature condition may change when using the monitor together with the optional equipments recommended by SHARP. In such cases,
please check the temperature condition specified by the optional equipments.
As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement
without prior notice. The performance specification figures indicated are nominal values of production units. There may be some deviations from
these values in individual units.
(For SHARP dealers and service engineers)
• When installing, removing or moving the monitor, ensure that this is carried out by at least 4 people. (PN-L652B: at least 2
people.)
• Be sure to use a wall-mount bracket designed or designated for mounting the monitor.
• This monitor is designed to be installed on a concrete wall or pillar. Reinforced work might be necessary for some materials
such as plaster / thin plastic board / wood before starting installation.
• This monitor and bracket must be installed on a wall which can endure at least 4 times or more the weight of the monitor.
Install by the most suitable method for the material and the structure.
• To attach a VESA-compliant mounting bracket, use M8 screws that are 3/8 inch (10 mm) to 1/2 inch (12 mm) longer than the
thickness of the mounting bracket.
• Do not use an impact driver.
• When moving the monitor, be sure to hold the areas shown in the figure below. Do not grasp the screen. This may cause
product damage, failure, or injury.
• If you need to temporarily place the monitor on a table or other surface during installation, spread a thick soft cloth on the
table to prevent damage to the screen and table.
• After mounting, please carefully ensure the monitor is secure, and not able to come loose from the wall or mount.
• Do not use any screw holes other than those for mounting brackets, located on the rear of the monitor, for installation.
Specifications
PN-L752B
AC 100 - 240 V, 4.6 A,
50/60 Hz
400W
Approx. 67-5/16 (W) x 3-3/8 (D)
x 40-1/8 (H) (1709.4 x 85.7 x
1019.8)
Approx. 109.1 (49.5)
Mounting Precautions
3/8 - 1/2 inch (10-12 mm)
Screws (M8)
Mounting bracket
Monitor mounting
PN-L652B
AC 100 - 240 V, 3.7 A,
50/60 Hz
330W
Approx. 58-5/8 (W) x 3-3/8 (D)
x 35-5/16 (H) (1488.4 x 85.5 x
896.6)
Approx. 80.5 (36.5)
9
E