Brandt BFV30B Manual De Instrucciones página 20

c) Refilling the water tank
Which water to use:
The iron can be used with tap water, but if you live in a region where the water is very hard, mix
untreated tap water with distilled or demineralised water in the following proportions: -50% tap
water, -50% distilled or demineralised water.
1. Ensure that the iron is unplugged and that the temperature control button is set to Min
(minimum
2. Open the water filling hole on the front of the handle.
3. Hold the iron at a 45° angle and fill the water tank (do not exceed the maximum level
indicated on the side of the iron) using the water measuring recipient provided.
4. Close the lid of the hole.
- Do not put any objects in the water tank.
- Do not add water when ironing or when the iron is hot.
A special non-removable filter installed in the tanks softens the water and prevents the
accumulation of limescale on the soleplate.
3) USING YOUR IRON
a) Dry ironing
1. Put the iron in the vertical position.
2. Set the steam slider to "0".
3. Plug the lead into an earthed power socket.
4. Adjust the thermostat to the fabric to be ironed.
5. The water may remain in the water tank when dry ironing.
WARNING! Always start by ironing fabrics requiring low temperatures and gradually
continue to materials requiring a higher temperature.
6. Once connected to the power supply, the two LEDs light up.
7. When the red LED on the bottom of the iron switches off, this means that you can
start to iron. The red LED on the handle is still on.
Check the washing label to know which temperature to use for each item of
clothing.
19