Descargar Imprimir esta página

SurfaceMaxx SGY-PWA1082 Manual De Instrucciones

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

PRODUCT SPECIFICATIONS
COMPONENT
Pressure Rating from
Temperature Rating
Hose Diameter
Fitting Size
WARNING:
1. SurfaceMaxx will not be held liable for any damages, losses, or injury due to the misapplication or
misuse of this product.
2. ALWAYS wear ANSI approved safety glasses, protective clothing, and proper hand and foot protection.
Always keep people, pets, or animals clear from any work area while using when using the drain
cleaner hose.
3. DO not place any part of your body in front of a spray nozzle.
4. Always keep a good grip on the hose when under pressure.
USES
1. Unclogging and cleaning drains, PVC and metal.
2. Use only with cold-water pressure washers.
3. DO NOT USE solvents, additives, or steam.
ASSEMBLY
1. Before attaching the drain cleaner hose to the spray gun:
a. Remove the wand from the spray gun.
b. Turn on the water and run water through the pressure washer, hose and spray gun without the
pressure washer running.
CAUTION:
Follow pressure washer safety instructions.
2. Connect the drain cleaner hose to the spray gun.
INSTRUCTION SHEET
Drain Cleaner Hose
MODEL #SGY-PWA1082 / PWA1083 / PWA1084
SPECIFICATIONS
1000 to 3600 PSI
50° F - 140° F (10° C - 60° C)
7/16"
1/8"
www.surfacemaxx.com
1
OPERATION
1. Insert the drainer cleaner hose end into the drain/pipe opening at least 12 inches in the direction of the
clog.
2. Squeeze the spray gun trigger, this will maintain the flow of water.
3. As the line advances a few feet, pull back about halfway before resuming forward again or pulse the
trigger several times.
You can also twist the line clockwise to help move the line forward.
4. When drain/pipe is clear, remove the drain cleaner hose with care. Pull back and stop the flow of water
before the nozzle reaches the opening of the drain/pipe.
5. DO NOT kink the line. Keep away from sharp or heated surfaces.
6. Turn off the pressure washer and disconnect the coupling.
7. Store the hose out of direct sunlight and be sure to drain all water from the hose.
www.surfacemaxx.com
2

Publicidad

loading

Resumen de contenidos para SurfaceMaxx SGY-PWA1082

  • Página 1 Fitting Size 1/8” WARNING: 1. SurfaceMaxx will not be held liable for any damages, losses, or injury due to the misapplication or misuse of this product. 2. ALWAYS wear ANSI approved safety glasses, protective clothing, and proper hand and foot protection.
  • Página 2 1/8” ADVERTENCIA: 1. SurfaceMaxx no se responsabiliza de ningún daño, pérdida o lesión debidos a la mala aplicación o al mal uso de este producto. 2. Utilice SIEMPRE gafas de seguridad aprobadas por el ANSI, ropa protectora y protección adecuada para manos y pies.

Este manual también es adecuado para:

Sgy-pwa1083Sgy-pwa1084