Ricatech RR790 Manual De Usuario página 5

2 In Standby Mode, press and hold PROGRAM /
- The hours digit starts flashing
3. Press the FF/ or FB/
4. Press PROGRAM /
5. Hold down FF/ or FB/
6. Press PROGRAM /
7. Press PROGRAM /
Setting the Timer
The unit can be used as an Alarm Clock, whereby the selected source (CD, TUNER, USB, SD CARD OR PHONO) starts
playback at a preset time. Make sure the clock is set before using the Timer.
1. In Standby Mode, press and hold TIMER /
flashing on the display. Press TIMER /
setting.
2. Press FF/ or FB/
on the remote to enter the ‗Minutes' setting mode.
3. Press TIMER /
4. Press FF/ or FB/
on the remote again to begin ―SYSTEM POWER OFF‖ Timer Setting.
5. Press TIMER /
" and ―TURN OFF‖ starts flashing on the display.
Icon "
on the Remote Control again to begin the 'Timer' setting.
6. Press TIMER /
7. Press FF/ or FB/
on the Remote Control to enter the ‗Minutes' setting mode.
8. Press TIMER /
9. Press FF/ or FB/
10. Press TIMER /
The default is set at TUNER mode.
repeatedly to set the hours.
again to confirm.The minutes digit starts flashing
repeatedly to set the ‗Minutes'.
again to confirm.The ‗minutes' digits stop flashing, the clock begins to run.
to select between 12 and 24 hours, as below:
on the remote over 1 second, icon
again on the Remote Control to begin the ―SYSTEM POWER ON‖ Timer
repeatedly to set the ‗Hours'.
repeatedly to set the ‗Minutes'.
repeatedly to set the ‗Hours'.
repeatedly to set the ‗Minutes'.
on the remote again to begin SETTING THE SOURCE to wake up from.
‗TUNER' will start flashing on the display.
for over 1 second.
and the words ‖ TURN ON‖ start
" "