Velux INTEGRA FMG-R Manual De Instrucciones página 5

Congratulations on your new VELUX INTEGRA
product!
Thank you for buying this VELUX INTEGRA
The remote control has been produced and tested in accord-
ance with the newest methods and strictest requirements and
will help you to get the most out of your VELUX products.
IMPORTANT:
The remote control for the blind is delivered with the blind.
The remote control delivered with the window cannot operate
the blind.
Initial set-up
A
The next three steps must be completed within 10 minutes.
1. FSK: Switch on the blind.
FMG-R, FMK-R: Connect blind to mains supply (230V).
2. Remove strip from remote control.
3. Press RESET button (for 1 second) on the back of the remote
control with a pointed object.
The blind can now be operated.
Note: If the 10 minutes are exceeded, switch off the blind (FSK)
or disconnect blind (FMG-R, FMK-R) from mains supply and
carry out initial set-up procedure again.
2 VELUX
®
product.
®
ENGLISH
Operation
B
Keys for operating the blind (A)
OPEN or CLOSE
Short press: The blind will travel to maximum opening or clos-
ing position.
Long press: The blind will travel until the key is released.
Stop key (B)
Press: The blind stops.
Replacement of batteries
C
Insert new batteries (type AAA, 1.5 volt x 2) as shown.
Fitting of holder for remote control
D
Note: Before the holder is fixed to the wall, it is recommended
to check if the remote control is able to operate the relevant
products from the fixed position.
Fixing of remote control
E
If required the remote control can be fixed to the holder.
ENGLISH
VELUX 3