Herschel Manhattan 3000 Instrucciones De Instalación Y Funcionamiento página 6

CAUTION:
• Ensure mains power is OFF and the unit is cool before commencing installation.
• The supplied mains cable must not contact the top surface of the heater during operation.
• Heater must not be located immediately above or below a socket outlet. Electrical connections must
be made outside of the footprint of the unit to avoid heat build-up in the connection.
Joists, beams and rafters shall not be cut or notched to install the appliance.
•
• This heater is not intended for recessed installation.
• The identification mark and model reference should be visible after installation.
• The fixed wiring insulation coming into contact with parts with a temperature rise of greater than 50°C
must be protected, for example, by sleeving having an appropriate temperature rating.
Ensure that wires are properly secured and cannot be pulled by small children.
•
INITIAL USE:
The power switch on the side of the MANHATTAN has 2 positions:
Position O (Off)
•
• Position I (On - standby)
To use the heater, switch the power switch to Position I. Then use the remote control as described below to
adjust the power up or down or use the countdown timer. There may be odour or vapour from the heater
on initial use or if it has not been used for an extended period. This is normal.
OPERATION BY REMOTE CONTROLLER:
Insert 2 x AAA Alkaline batteries into the remote control.
All Herschel remote controls have the same frequency, so it is possible to control several heaters with just
one remote.
Functions of the remote control are as follows:
Button Function (Heater On)
1 Turns heater on or off
2 Increase Heat Level or
Timer hours
3 Decrease Heat Level or
Timer Hours
4 Enable Timer adjustment
Enable Heat Level
5
adjustment
Remote Control Function
Function (Heater Off)
Turns heater on to
Level 1 (minimum)
Turns heater on to
Level 2(Maximum)
0 - 24
ENGLISH
LED Display on
Heater
L1 50%
L2 100%
[0H] - [24H]
L [n]