Publicidad
Step 5
Carefully fl ip the assembled parts over.
å
Turn six BLACK 9/16" FLAT HEAD SCREWS (32S) into
å
the UPPER PANEL (D) until the shoulders of the SCREWS
rest on the surface of the UPPER PANEL.
NOTE: Do not overtighten the SCREWS.
å
Slide three SLATS (F) onto the UPPER PANEL (D). Line up
å
the grooves in the SLATS over the heads of the SCREWS
in the UPPER PANEL. The SLATS should rest against the
TOP MOLDING (I).
NOTE: If the SLAT comes up off of the SCREWS, remove
å
it and slide it on again.
www.sauder.com/services
BLACK 9/16" FLAT HEAD SCREW
(6 used in this step)
D
F
F
419905
Apply pressure with your hands
as you guide the SLATS over the
SCREWS and onto the UPPER PANEL.
32S
I
F
Shoulder
Page 9
Publicidad
