Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Wet/Dry AutoVac by Wagan Tech
USAGE
Vacuuming Instructions
1. Select the attachment you wish to use and connect it to one end of the hose.
2. Connect the other end of the hose to the Vacuum Port.
3. Plug the DC cord into your DC socket.
s You must ensure that all other electrical equipment in the car is switched off when vacuum is
in use, including other items plugged into the 12V socket.
4. Locate the power switch and turn the vacuum on.
s For optimal performance and to avoid draining your battery, your vehicle's engine should
be running when operating your vacuum.
5. When finished, turn the vacuum off and then unplug the DC cord from the DC socket.
6. Clean out dirt, debris, and etc from the reservoir by unlatching the four clips in the same
manner as described in "Parts & Accessories".
Inflating Instructions
1. Connect the Inflator Adapter to one end of the hose.
2. Connect the other end of the hose to the Inflator Port.
3. Follow steps #3-5 from the "Vacuuming Instructions".
CARE & MAINTENANCE
1. DO NOT submerge vacuum in water. You may wipe the outside with a damp cloth.
2. After using the Wet/Dry AutoVac to vacuum up liquid, make sure to clean the reservoir and
filter. Let all parts dry fully before storing it away for future use.
FILTER CLEANING & REPLACEMENT
1. Unlatch the four securing clips from the dirt reservoir and detach.
2. Locate cloth filter around air intake guard and remove carefully.
3. Clean filter by hand with mild soap and warm water. Allow to dry thoroughly.
4. To order replacement filters, visit www.wagan.com (Part AA5321).
s Do not run vacuum without filter in place.
4
®
www.wagan.com
Publicidad
Tabla de contenido
