JFA Electronicos REDLINE Manual De Instrucciones página 10

REDLINE REMOTE CONTROL - INSTRUCTION MANUAL
CONTROL CODING
To encode a control, follow these steps:
1- Press the "M" key on the receiver (Indication 9). The LED ACTION
(Indication 8) will have permanent access;
2- Press the (+) key on the control (Indication 1). Verify that the led
ACTION (indication 8) will blink 1 time, indicating that the control has
been encoded with the REDLINE receiver.
3- After nishing this process, LED ACTION (Indication 8) lights up will
delete immediately.
IMPORTANT REMARK
The panel will not work if the procedure
control coding is not performed.
RECOMMENDED INSTALLATION FOR THE
RECEIVER (W/R MODE)
INTERFAZ W/R
(CABLE P2)
UNIT RECEIVER PLAYER
9