Ryobi PCL662 Manual Del Operador página 5

WARNING:
Do not direct the light beam at persons or animals and
do not stare into the light beam yourself (not even from a
distance). Staring into the light beam may result in serious
injury or vision loss.
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
APPLICATIONS
You may use this tool for the purpose listed below:
 General illumination of most work area spaces
INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 7.
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured before
beginning operation.
 Depress the latches to remove the battery pack.
For complete charging instructions, see the operator's manu-
als for your battery pack and charger.
WARNING:
Battery products are always in operating condition.
Therefore, remove the battery pack when the product is
not in use or when carrying at your side.
POWER BUTTON (HIGH/MEDIUM/LOW/OFF)
See Figure 2, page 7.
The work light will be in the OFF position until the power
button is pressed.
 Connect the product to the battery pack.
 Press and release the button to cycle between HIGH,
MEDIUM, LOW, and OFF.
OPERATION
 Press and hold the button for two seconds while ON (in
any mode) and the light will shut off.
 Press and hold the button for two seconds while OFF
allows the light to go into low mode.
NOTE: This light is equipped with a low voltage indicator.
If the light flashes 3 times while a battery pack is installed,
this indicates a low charge condition. Install a charged
battery pack and resume operation.
HANGING THE LED AREA LIGHT
See Figure 3, page 8.
WARNING:
Only hang or mount LED area light in an area where no
electrical wires, utility cables, pipes, or other obstructions
are located. Contact your local utility company or a
qualified electrician if you are unsure. Do not hang area
light from any electrical power cord. Ensure area light is
securely installed to prevent falling object hazard. Failure
to follow these instructions can result in electrocution,
electrical shock, or other serious personal injury.
 Lift the handle to the desired position for hanging.
 Be careful not to hang the area light in a position that
prevents normal operation of the light.
USB DEDICATED CHARGING PORT
See Figure 4, page 8
The USB dedicated charging port provides charging power
of 5 Volts DC at up to 2.1 Amp for your cell phone, MP3
player, or other USB devices.
 Press the power button to turn the light on.
 Connect one end of a USB cable (not provided) to your
USB device.
 Connect the other end of the USB cable (not provided) to
the USB dedicated charging port to begin charging the
device.
 The USB charging capability is active when the light
is turned on. It will remain active for charging for
approximately 8 hours after the light has been turned off.
 If the light is turned off for approximately 8 hours, the
USB port will deactivate. To continue using the light for
charging, turn the light on again.
 The light may then be turned off and used for an additional
approximately 8 hour charging period.
5 – English