Before The First Use; Unpacking; Requirements For The Installation Location; Boiling Water - Graef 18837 Manual De Instrucciones

Do not use any aggressive or abrasive cleaning
•
agents and do not use any solvents.
Do not scratch off stubborn soiling with hard
•
objects.
Do not rinse the unit off in water or immerse it
•
into water.

Before the first use

Read these operating instructions thoroughly
and keep them handy for referral later on.
This unit brings water to boil in a few minutes.
To clean the unit, first fill the unit with clear,
•
cold water and then boil it. Subsequently pour
away the water.

Unpacking

To unpack the unit, proceed as below:
Take the unit out of the carton.
•
Remove all pieces of the packing.
•
Remove any possibly extant labels on the unit
•
(do not remove the rating plate).

Requirements for the installation location

For safe and flawless operation of the unit, the
place of location must meet these prerequisites:
The unit must be set up on a firm, flat, level
•
and non-slip base that has sufficient load bear-
ing capacity.
Make sure the unit cannot fall over.
•
Select the location so that children cannot reach
•
the hot surfaces of the unit and cannot touch
the cable.

Boiling water

Take hold of the base station and unwind the
•
cable as far as it goes.
Open the lid and fill the unit with water
•
Important
Make sure you do not exceed the internal maxi-
mum filling level mark.
Fill the unit so that the water level is definitely
between the minimum and maximum indicator
line.
Close the lid and put the unit back onto the
•
base station.
Plug the plug into the electric socket.
•
Push the on/off switch.
•
The unit is now switched on.
•
EN
11