Behringer UL 1000G2 Guia De Inicio Rapido página 27

Equalizer (EQ)
5. The treble at 10 kHz is enhanced by 6 dB while
the EQ is enabled.
6. Press the SET button repeatedly until "EQ"
flashes in the receiver display. Use the up/
down buttons to enable (EQ ON) or disable (EQ
OFF) the Equalizer.
Limiter (LIM)
7. To protect ears from injury, the Limiter
function limits the level of audio signal to
earphones at 400mV. It is advised to turn LIM
ON if the receiver display indicates audio level
is at maximum.
8. Press the SET button repeatedly until "LIM"
flashes in the receiver display. Use the up/
down buttons to enable (LIM ON) or disable
(LIM OFF) the Limiter.
Mixer (MIX)
9. Enable the Mixer function to listen to the mix
of two mono signals, balance and regulate
their volume.
For example: If the LEFT INPUT contains mono
audio signal from instruments and the RIGHT
INPUT contains mono audio signal vocals. The
singer can monitor and adjust the volume
balance between the instruments and his own
voice and the overall volume level using the
belt-pack receiver with MIX ON setting.
10. Press the SET button repeatedly until "MIX"
flashes in the receiver display. Use the up/
down buttons to enable (MIX ON) or disable
(MIX OFF) the Mixer.
Squelch (SQ)
11. The Squelch function enables you to set a
minimum threshold of signal received by
the receiver. The setting consists of 3 bar
levels - Low, Medium, and High. The receiver
rejects signals below the set threshold and
helps eradicate any unwanted audio signal
transmitted by the transmitter.
12. Press the SET button repeatedly until "SQ"
flashes in the receiver display. Use the up/
down buttons to set Squelch at Low, Medium,
or High.
Balance
13. Adjust volume balance between left and
right channels of a Stereo signal using the
up/down buttons.
The audio is centered at -0- level. There are 9
levels available each for offset to the right
channel and offset to the left channel. Positive
values (1-, 2-, 3-, 4-, 5-, 6-, 7-, 8-, 9-) offset
towards the Right, while negative values (-1-,
-2-, -3-, -4-, -5-, -6-, -7-, -8-, -9-) offset towards
the Left channel.
MONO
EQ LIM MIX
SQL
14. NOTE: To ensure the transmission of a stereo
audio signal, the transmitter must be set in
stereo mode and an audio signal must be
present at the LEFT INPUT and the RIGHT
INPUT.
Locking the Receiver against changes
15. Press the SET button repeatedly until the LOCK
icon flashes in the receiver display. Press up/
down to select LOCK ON or LOCK OFF. LOCK ON
function disables buttons, so no unwanted
changes can be made accidentally.
16. NOTE: LOCK ON is enabled automatically if no
operation is performed for 5 seconds. Under
LOCK ON status, press and hold SET button for
2 seconds to disable LOCK momentarily and
enables you to make changes.
Battery Power Status
17. Remaining battery power status is displayed
via four bars. If no bars are visible on the
battery symbol, the BATT LED will turn Red
from Blue. The batteries should then be
replaced immediately.
27
Quick Start Guide