Publicidad
Idiomas disponibles
Idiomas disponibles
CONNECTION AND OPERATION
Select the operation mode by pressing the MODE buttons. To make changes within a mode use the SET
buttons and press ENTER to confirm.
The following table shows you all the operating modes and the possible settings for each mode.
DMX CONTROL
AUTOMATIC AND
MANUAL MODES
GENERAL SETTINGS
DMX CONTROL
GENERAL SETTINGS
RESET
RESTORE
DMX CONTROL
To control the device using a DMX controller:
-
Select the desired DMX operation mode: 9 or 14 channels as shown in the table above. Use the MODE
and SET button to select the number of channels and press ENTER to confirm the setting.
-
Select the DMX address to control this LED bar with a value between 1 and 512. Use the MODE and SET
button to select the DMX address and press ENTER to confirm the setting.
-
Below are the features of each channel in the different DMX operating modes:
MODE
d001 - d512
NAFA
NASL
SLAu
NStC
* Those designated as "slaves" do not receive instructions
NStS
PAn
rPAn
TiL
rTiL
diS
rdiS
9CH
14CH
PA54
PA36
PA18
Ti27
Ti18
Ti09
rESt
LoAd
- 3 -
FUNCTION
Address for DMX control
Fast Auto Mode (FASt)
Slow Auto Mode (SLoU)
Slave mode (Son)
Auto-only* mode (Crun)
Sound activated (Srun)
PAN normal
PAN inverted
TILT normal
TILT inverted
Information on the normal display
Inverts the information on the screen
Mode 9 DMX control channels
Mode 14 DMX control channels
PAN maximum: 540º
PAN maximum: 360º
PAN maximum: 180º
TILT maximum: 270º
TILT maximum: 180º
TILT maximum: 90º
Perform a check of the device
Return to factury settings
EN
Publicidad
