Publicidad
Idiomas disponibles
Idiomas disponibles
Fault
Lid difficult to close
Lid difficult to open
Steam escaping from the
edge of the lid
Steam escaping through
the safety valve
The safety valve does
not rise
Steam continuously
escaping through the
release valve
The display shows the
message "Lid"
The display shows the
message "E1"
The display shows the
message "E2"
The display shows the
message "E3"
The display shows the
message "E4"
Possible cause
The cover's sealing gasket is not
properly seated.
The safety valve is sticking out.
The cover's sealing collar is not
fitted correctly.
There is pressure inside the pot.
The safety valve is jammed
sticking out.
The cover's sealing gasket has
not been fitted.
The sealing gasket is damaged.
There are food remains on the
cover's sealing gasket.
The lid has not been closed
correctly.
There are food remains on the
safety valve's silicone seal.
The safety valve's silicone seal
is worn.
There is not enough food or
water inside the removable pot.
The lid's locking catch is
blocking the safety valve. The lid
has not been closed correctly.
The steam release valve knob is
not in the 'Seal' position.
Pressure control failure.
The lid is open or not in the
correct position for the selected
program.
The lower temperature sensor is
damaged.
Temperature sensor short
circuited.
Temperature sensor overheated.
Temperature above 200ºC.
Faulty pressure switch, the
temperature is below 80ºC.
Solution
Fit the sealing gasket correctly.
Press the safety valve down gently
so that it stays inside.
Turn the cover so that the collar
faces outward.
Use the steam release valve to
reduce the internal pressure. Open
the lid once all pressure has been
released.
Press the safety valve down gently
so that it stays inside.
Fit the cover's sealing gasket.
Replace the sealing gasket.
Contact the Technical Support
Service.
Clean the sealing gasket.
Open the lid and close it again.
Clean the silicone seal.
Replace the safety valve's silicone
seal. Contact the Technical
Support Service.
Add water or food depending on
the recipe.
Close the lid fully.
Turn the knob to the 'Seal'
position.
Contact the Technical Support
Service.
Close the lid in order to cook.
Contact the Technical Support
Service.
Contact the Technical Support
Service.
Contact the Technical Support
Service.
Contact the Technical Support
Service.
Publicidad
