Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLEM
Treadmill will not start.
Running speed inaccurate.
Running
belt
is
centered.
Computer is not working.
E01: Message failure.
E02:
Burst
protection.
E03: No speed sensor
signal.
E05:
Current
overload
protection (Self Protecting
System).
TROUBLESHOOTING
POSSIBLE CAUSE
Not plugged in.
Safety Key (No. C32) is
not inserted.
Not calibrated correctly.
Speed set in the wrong
units of measurement.
Running belt tension is not
not
correct on the left or right
sides of the running board.
Wires from the console
and bottom control board
not properly connected.
Transformer is damaged.
Wires from the console
and bottom control board
are
not
connected.
Incoming voltage is lower
clash
than 50% of the required
voltage.
Speed
sensor
cannot be received by the
control board.
The incoming voltage is
too low or too high. The
control board is damaged.
A moving part of
treadmill
is
therefore, the motor is
unable to rotate properly.
SUGGESTED ACTION
Plug power cord into outlet.
Insert Safety Key (No. C32).
Re-calibrate speed setting.
Change
units.
Tighten the left and right
adjusting bolts of the rear
roller.
Check wire connections from
the console to the bottom
control board.
If the transformer is damaged,
contact customer service.
Check wire connections from
the
properly
control board.
Check if the incoming power
supply is the correct voltage.
Check that the sensor wire is
properly
signal
damaged,
Check to see if the magnetic
sensor is damaged, replace if
necessary.
Restart the treadmill. Check
the
ensure it's correct. Check the
control
damaged.
Inspect moving parts of the
treadmill to ensure that they
the
are operating correctly. Check
stuck
and
the motor, listen for strange
noise and check for a burning
smell. Replace the motor if
necessary.
22
setting
to
proper
console to the
bottom
connected.
replace
wire.
incoming
voltage
board,
replace
If
to
if
Publicidad
