EZiclean Cycloboost R6 wash Manual De Instrucciones página 15

Caution:
Do not replace the mop while the machine is running.
Do not apply too much pressure to the mop module to avoid damaging it.
Do not use a screwdriver or sharp object to remove the mop to avoid damaging it.
Do not use any liquid other than water or a mixture of water and cleaning solution (1 part solution
to 7 parts water).
2
3
4
2/ Place the clean and dry mops (4) on the wash module.
3/ Clip the mop module onto the tube of your upright hoover
Caution: To avoid any inconvenience, it is strongly recommended to use the special floor brush
(with both nylon and rubber bristles). The use of the soft floor bristle (entirely nylon) could result in
1/ Clean the mops with warm water
and a little soap.
2/ Rinse well.
3/ Leave to dry in the open air.
4/ Make sure they are completely
dry before reinstalling them on the
appliance.
EZIWIPE™ WASH MODULE
1
USE
1/ Remove the suction brush from your upright hoover
4/ Switch on the hoover.
wet dust marks on your floor).
MAINTENANCE OF THE MOP
1 - Tank
2 - Connectors
3 - Microfiber mop
4 - Tank cap