Optimus AET-100 Manual De Instrucciones página 2

INSTRUCTION MANUAL
SPECIFICATIONS
Model
Rated Power (RMS) 100 V
Impedance
Sensitivity
Sound Pressure
Sensitivity EN54-24
Freq. Range
Freq. Response
Dispersion 1kHz / 4kHz
Operating temperature
Protection range
Dimension (mm) and weight
Finish
Mounting
Power selection
EN54 standard
Other
Accessories (not included)
INSTALLATION GUIDE
- Mount the brackets to the ceiling with suitable fixing material (not included).
- Secure the speaker to the brackets with M8 x 20 screws and M8 washers. Please use a torque of 16 Nm for tightening the screws of the brackets.
Feed the speaker cable through the PG gland and connect the cable to the ceramic terminal block according to your required power.
-
- Place the cover on the horn driver and screw it with the screws M8 x 25 and the steel and rubber washers M8.
Tightening the screws of the rear cover of the horn driver is done in 2 passes: Tighten all 8 screws with a torque of 2.0 Nm. Then retighten to 2.0 Nm again, to check that they all
-
have the same torque.
Recommended setting of EQ / DSP when using a STIPA test signal at maximum load: High pass (HP) 300 Hz to 400 Hz with 12 dB slew rate (Butterworth).
AET-100 Version 1.0
100 W, 50 W & 25 W
100 Ω, 200 Ω & 400 Ω
113 dB SPL at 1 W / 1 m IEC268-5
133 dB SPL at 100 W / 1 m IEC268-5
101 dB SPL at 1 W / 4 m
280 ~ 9.000 Hz
250 ~ 10.000 Hz
h=35º v=25º / h=54º v=15º (-6 dB)
-25ºC ~ +70ºC
1228 x 832 x 413 mm, 16 kg
Plastic (UL 94 V-0), black color
Stainless steel brackets (not included)
Terminals (4-pin)
Loudspeaker for voice alarm systems for fire detection and fire alarm
systems for buildings
Horn speaker, 100W, Type B
CE-Symbol according 93/68EWG
Thermal fuse and ceramic terminals
AET-100PH (Premium bracket, single piece)
AET-100EM (Standard bracket, 4 pieces)
1/1
TUNEL SPEAKER
WARNING:
. Installation by qualified personnel only.
. Speakers must be wired in parallel and connected to
the correct line terminals of amplifier.
. Ensure that all speakers have the same polarity with
respect to each other.
.
Do not select another tapings if the speaker is in use.
.
No naked flame sources, such as lighted candles,
should be placed on the apparatus
AET-100
IP65
EN 54-24:2008
Ref. No.: DOP_AET-100
ID-Code: A133T54
1438/CPR/xxxx
AET-100
.