SOLAC MV1501 Instrucciones De Uso página 9

Disassemble the handle,pull out the cord wrap.
•
(Fig. 3)
Push release tap on tube,then insert tube as-
•
sembled with handle into main body.Make sure
that the locking tab snaps into place.
Disassemble the tube,push release button on
•
back of main body, then pull it out.(Fig. 4)
USING STEAM MOP
Important:never use the steam mop without
•
the micro-fiber cleaning pad attached to the
mop head or without water in the water tank.
Sweep the floors before using the steam mop.
•
Place the micro-fiber cleaning pad underneath
•
the mop head.Make sure that the velcro are
facing up.(Fig. 5)
Important:always insure that the unit is "unplu-
•
gged" from the wall receptacle prior to filling
and before attaching the micro-fiber cleaning
pad to the bottom of the mop head.Never use
the steam mop without the micro-fiber cleaning
pad attached to the mop head.
Place steam mop on docking tray(Fig. 6)
•
Push the "PUSH"button on main body, lift up to
•
remove the water tank.(Fig. 7)
Turn the cap counter clockwise(Fig. 8),using
•
the filling funnel,pour the water into water tank.
Do not overfill the unit past the MAX fill line on
the water tank.
Replace cap onto the water tank.
•
Replace water tank onto main body.
•
Twist the quick release cord holder to unwrap
•
the power cord completely.
Plug into electrical outlet,the same to voltage
•
on rating plate.
Press the power switch. The power-on light will
•
glow red while the mop is heating up.
Select the level of steam in the handle using
•
the buttons on the handle to raise or lower the
mode (low, medium or high). (Fig. 9)
It takes approximately 45 seconds for the unit
•
to heat up and the steam to be ready.
Once hot, the power light will flash green while
•
in the upright position and solid green while in
use.
Wait seconds,dampen the micro-fiber cleaning
•
pad first, begin mopping with a forward and
backward motion,it will release steam as you
mop.
When water tank is empty,the steam mop will
•
stop emitting steam.Unplug the power cord
from the electrical outlet and refill the water
tank following the instructions above.
When the unit is under vertical stand, the pump
•
will stop working for the static protection
Remove cleaning pad,put carpet glider to
•
clean the tile at home.
FEATURES
Steam mop utilizes steam to remove tough
•
grease, dirt and grime. Cleaning house without
using harsh chemicals, therefore it is perfect-
ly ecological. It can be used to clean your tile,
hardwood, ceramic tile, linoleum and vinyl
floors.
Quick&easy
•
Eliminates rinsing, wringing, carrying buckets
•
of water and redistributing the dirt on the floor.
Save your time to clean up the floors.
Sanitizing
•
Powerful steam helps for superior cleaning and
•
sanitizing. Kill 99,99% of viruses and germs
No chemical used
•
Use tap water or distilled water, perfectly eco-
•
logical.
Quick Start-up
•
Steam is ready in just 45 seconds
•
Reusable and washable cleaning pad
•
Static Protection
•
When the unit is under vertical stand, the pump
•
will stop working for the static protection
Energy saving for battery
•
Without touching select switch, it will stop wor-
•
king to prolong use time for battery.
CARE AND MAINTENANCE
If you consistently use distilled water, cleaning
•
the water tank is not necessary.
CAUTION:
This appliance must be unplugged from the
•
electrical outlet before performing any cleaning
or maintenance tasks on the unit.
Care the micro-fiber cleaning pad
•
Wash the pad with a mild detergent.
•
Put it in washing machine using the warm wa-
•
ter setting, and separately from other fabrics or
placing them in a garment bag first.
RINSING OUT THE STEAM MOP
Let the appliance cool down completely before
•
cleaning or storing.
Empty all water from the water tank after each
•
use.
EN