Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT
Always read the instructions before you start using your
power tool.
BASIC SAFETY PRECAUTIONS
Keep the work area clean. A cluttered site can cause
damage.
Do not use power tools in damp or wet locations. Do not
expose power tools to rain. Keep the workplace well lit.
Do not use in locations with gas / flammable liquids.
When working with the machine, do not touch other
devices connected to the mains.
Do not allow children to remain close to the workplace.
All people should stay away.
You should keep all tools in a dry, high and locked.
Get a job with better quality if the suit the speed of the
machine. Avoid unnecessary burdens that may
endanger the operator and the power tool.
Do not force small tools and accessories to perform the
work of larger machines, and do not use for work
inadequate.
Do not wear loose clothing or jewelery, they can
become trapped in the tool. We recommend the use of
gloves and work shoes. Long hair should also be
arrested.
Always use eye protection. If dust, also use mask.
Do not hold the tool by the cord. Should not turn off the
electrical current to stop the tool. This procedure
should be done on the switch. Keep cord away from
heat, fuel and sharp edges.
Keep yourself in balance.
Keep tools clean for better and safer performance.
Follow the maintenance instructions. Inspect cords
regularly and replace them if damaged. Keep your
hands dry, clean and free of oil.
Disconnect the tool from the mains when not being
used, and when replacing the accessories (such as drills,
discs, etc ...)
If the tool is connected to the mains, do not transport
with fingers in contact with the switch. On the other
hand, make sure the switch is off when plugging in the
mains.
If you need an extension, make sure that the wire of the
same section has a size equal to or greater than the
cable from the power tool.
Stay alert, attentive to his work, and use common sense.
Do not continue to work if you are tired.
Before starting work with any tool, must prove that
there are no damaged parts. Carefully check the
installation and tuning of all moving parts.
8
Any damaged part should be properly repaired or
replaced by a qualified technician. Do not use the tool if
the switch is not working.
The use of an accessory inappropriate represents a
potential risk to the user.
This tool complies with the safety regulations in force.
Your repair should only be performed by a qualified
technician. Otherwise, the risk to the user is real.
ADDITIONAL SAFETY RULES
It is recommended that the user use goggles.
In operation, the cable should be in the rear of the tool
to avoid being damaged.
Before using the tool ensures that the protective device
of the disk is implemented well. The use of the tool
without the guard is strictly prohibited.
Before commencing operations, make sure that the disc
brake button is OFF.
When inspection, adjustment and replacement of the
disc, be sure that the tool is not connected to the mains.
Before starting work, carefully check the disc status.
This should not be used to perform a crevice.
GRINDING WHEEL'S SPECIAL CAUTIONS
Do not connect the Chain Saw Sharpener if the grinding
wheel is damaged (cracks, broken or too worn out).
Use only grinding wheels with an inner diameter equal
to the original.
Do not overtighten the grinding wheel clamping nut. It
could lead the disc to break or to disintegrate.
Never work without the grinding wheel's protection
properly installed.
Always test the machine in operation before leaving
touch the chain.
Always keep your hands away from the grinding wheel.
If the grinding wheel vibrates, immediately turn off the
switch.
Whenever you need to replace the grinding wheel, first
turn off the machine's electric current.
CAUTION
This machine is only suitable for sharpening chains of
chainsaws / electric chain saw. Never try to sharpen any
other tool.
Publicidad
