Publicidad
Idiomas disponibles
Idiomas disponibles
BEFORE FIRST USE
1. Extract the various components from the packaging, check that they are intact and
complete, gently remove any protections and labels. The packaging includes:
No. 1 Motor body
•
•
No. 1 Pair of eggbeaters
No. 1 Whisk
•
No. 1 USB-C cord
•
•
No. 1 Charging adapter
No. 1 Accessory support base
•
2. Before the first use, or after long periods of non-use, wash all the parts that come into
contact with foodstuffs as indicated in the "Cleaning and Maintenance" section.
Check that all the parts are properly assembled and in position
3.
before use
.
4. Charge the appliance.
RECHARGING THE BATTERY
1. Open the rubber protection on the motor housing. Connect the USB-C connector of the
cord to the motor housing.
2. Connect the USB-C connector to the charging adapter.
3. Connect the charging adapter to the wall socket.
4. The lights will flash during charging. The lights stop flashing when the appliance is fully
charged. See the "Indicator lights" section for details.
5. Approximately 4 hours are needed to fully charge the appliance. Do not recharge the
device for more than 12 hours.
6. The appliance can be charged while it is stowed in the storage base.
7. Once charging is complete, disconnect the adapter from both the power outlet and the
appliance. Do not turn on the device during the charging operation.
Note:
The appliance is shipped with the batteries approximately 30% charged. During use, one or
•
two LED indicator lights may turn on. The appliance will work properly even without being
charged first. It is recommended to fully charge the appliance before first use for best
performance.
•
To maintain optimum performance and battery life, it is recommended to charge the battery
in an ambient temperature between 15 ° C and 25 ° C. This precaution will prevent serious
damage to the battery itself.
INSERTING THE WHISK OR EGGBEATER ACCESSORIES
Check that the speed control is in position 0 (off).
Align the tabs on the shaft of the eggbeaters with the slots in the mixer (motor housing). Push
firmly until the eggbeaters are locked in position. Both eggbeaters can be inserted in both slots.
Note: The whisk must be used alone and can be inserted into both slots.
REMOVING THE WHISK OR EGGBEATER ACCESSORIES
Slide the speed control into position 0 (off).
Press the ejection button to eject the eggbeaters or the whisk.
Note: do not eject the eggbeaters or whisk during operation. Turn off the item sliding the speed
control to 0 and then eject the eggbeaters or the whisk.
15
Publicidad
