TFA 43.2033 Instrucciones De Uso página 2

TFA_No. 43.2033_Anleitung_03_23
LUMATIC GUARD
LED multi-function safety lamp
A: 5-LED-lights (above)
B: 15-LED-lights (in front)
C: ON/OFF button
D: Light sensor
E: IR motion sensor
F: Induction contact for
the charging station
A
Thank you for choosing this instrument from TFA.
1. Before you use this product
• Please make sure you read the instruction manual carefully.
• Following and respecting the instructions in your manual will prevent damage to your instrument and
loss of your statutory rights arising from defects due to incorrect use.
• We shall not be liable for any damage occurring as a result of non-following of these instructions.
• Please pay particular attention to the safety notices!
• Please keep this instruction manual safe for future reference.
2. Field of operation and all the benefits of your new instrument at a glance
• Night light with IR motion sensor (15 LEDs)
• Flashlight - always at hand in the right place, at once light without turning on (5 LEDs)
• Automatic emergency lighting during a power outage
• Comfortable charging at the socket (by induction)
• Built-in rechargeable battery
3. For your safety
• The product is exclusively intended for the field of application described above. It should only be used as
described within these instructions.
• Unauthorised repairs, modifications or changes to the product are prohibited.
Caution!
Risk of injury:
• Do not shine directly into the eyes with the flashlight.
• Keep this instrument and the charging station out of the reach of children.
• Protect the flashlight from overheating! Do not leave the flashlight on unattended.
• After removing the flashlight from the charging station, the lower side is heated by charging. Make sure
that the flashlight is cooled off before touching it. Turn off the flashlight after use.
• Risk of burns!
• Batteries containing lithium carry a risk of fire or explosion due to heat or mechanical damage!
• Protect it from high temperatures. Do not throw into fire, short-circuit or take apart. If the device becomes
hot while charging or the battery is no longer charged, this is a sign of a defect. Disconnect the device
from the charging power source immediately.
• The battery cannot and must not be replaced or removed by you. There is a risk of explosion if the battery
is replaced incorrectly. If necessary, a qualified person can obtain instructions on how to dismantle the
permanently installed battery from info@tfa-dostmann.de , should this be necessary for the purpose of
repairing or recycling the product.
Caution!
Risk of electrocution:
• Plug the charging station only into a socket installed in regulation manner and with a mains voltage of
220-230V!
• The mains socket must be installed near the equipment and it must be easily accessible.
• The charging station must not come into contact with water or moisture. Only suitable for operation in dry
interiors.
• Do not use the charging station if the housing or the main adapter is damaged.
• Operate the device out of reach of persons (including children) who cannot fully appreciate the potential
risks of handling electrical equipment.
• Pull the charging station out of the socket immediately if any fault occurs or if the charging station is not
used for a lengthy period.
• Only use the supplied charging station for the flashlight.
Important information on product safety!
• Do not expose the device to extreme temperatures, vibrations or shocks.
• Clean the devices with a soft damp cloth. Do not use solvents or scouring agents.
4. Operation
• Please charge it fully before the first use.
• If the illumination decreases, put the flashlight into the charging station.
4.1 Charging of the LED multi-function safety lamp
• Plug the charging station into a socket.
• For charging put the flashlight with the lower side into the charging station. The 15-LED lights show to the
front.
• For fully charge put the flashlight at least 8 hours in the connected charging station.
• The charging process is completed automatically.
4.2 Use as a LED flashlight
• Take the flashlight out of the charging station.
• When taken out, the 15 LED lights turn on automatically.
• Press the ON/OFF button again, the 15 LED lights turn off and the 5 LED lights (above) turn on.
• To switch off the flashlight press the ON/OFF button again.
4.3 Use as an infrared motion sensor
• Plug the charging station into a wall outlet. For the best sensor effect the socket should be located about
1.5 m above the ground.
24.03.2023 10:45 Uhr Seite 2
F
E
D
C
B
Operating Instructions
Instruction manuals
www.tfa-dostmann.de/en/service/downloads/instruction-manuals
• Put the flashlight with the 15-LED light forward into the charging station.
• Does the infrared motion sensor detect a movement about 2 to 3 m in front of the sensor, the 15-LED
lights will turn on automatically.
• The flashlight has a light sensor to turn on the light automatically only at dark.
• The flashlight will turn off automatically after a few seconds.
4.4 Use as an emergency light
• By power outage the 15-LED lamps turn on automatically.
5. Waste disposal
This product and its packaging have been manufactured using high-grade materials and components which
can be recycled and reused. This reduces waste and protects the environment.
Dispose of the packaging in an environmentally friendly manner using the collection systems that have been
set up.
Disposal of the electrical device
Caution! This device contains a built-in battery that cannot be removed without damaging the
housing. Improper removal represents a safety risk. Hand in the device unopened at the collection
point; the device and battery will be disposed of properly.
This product is labelled in accordance with the EU Waste Electrical and Electronic Equipment
Directive (WEEE).
Please do not dispose of this product in ordinary household waste. As a consumer, you are
required to take end-of-life devices to a designated collection point for the disposal of electrical
and electronic equipment, in order to ensure environmentally friendly disposal. The return service
is free of charge. Observe the current regulations in place!
WARNING!
Batteries containing lithium can explode!
• Batteries and rechargeable batteries containing lithium (Li=lithium) present a high risk of fire and explo-
sion due to heat or mechanical damage with potentially serious consequences for people and the environ-
ment. Pay particular attention to correct disposal.
6. Specifications
LED lamps
ϕ 5 120°LED / 1200 – 1300 mcd / 0,07 W
5-LED-lights:
ϕ 5 15°LED / 15000 – 17000 mcd / 0,07 W
15-LED-lights:
Range: up to 3 m
Operating time: 5-LED-lights – more than 2 hours
15-LED-lights – more than 1.5 hours
Infrared motion sensor
Distance / angle: 2 – 3 m /60°
≤5µA
Quiescent current:
Illumination time: approx. 20 seconds
Power consumption: Charging station
Input: 220-230V / AC / 50Hz / 0.01A
Battery: 052030 Li-ion Battery 3.7 V, 250MAH
Charging time: 8 hours
Dimension: 50 x 35 x 153 mm
Weight: 92 g (instrument only)
TFA Dostmann GmbH & Co.KG, Zum Ottersberg 12, 97877 Wertheim, Germany
No part of this manual may be reproduced without written consent of TFA Dostmann. The technical data are correct at
the time of going to print and may change without prior notice.
The latest technical data and information about this product can be found in our homepage by simply entering the
product number in the search box.
www.tfa-dostmann.de
Cat.-No. 43.2033
03/23