Publicidad
GB
AKO-80004A CONVERTER
1- Description
PT-100 converter at 4-20 mA.
2- Installation
Fix the converter using two screws (A), wire it by passing the cable through
the glands (B) supplied and close the cover using the 4 screws provided (C).
3- Warnings
Ensure that the operating conditions are not exceeded in the place of in-
stallation (see technical features).
Do not install it close to sources of heat, excessive dust, mechanical vi-
bration or where it might be exposed to direct sunlight or magnetic fields.
Submitting it to sudden temperature changes may produce internal conden-
sation. In this case, wait for about one hour before switching on the power.
Ensure that the supply voltage is within the admissible range (see technical fea-
tures).
Disconnect the power supply beforing performing any type of maintenance.
4- Wiring
AKO-15740/15742
1
2
INPUT NO.
1 2 3 4
+
mA
AKO
80004A
PT100
5- Technical specifications:
Robust ABS plastic box, grey. ..................................................
Power supply: ....................................................12 to 36 VDC
Protection: ......................................................................IP64
Calibration:......-100 to 350 ºC (-100=4 mA and 350=20 mA)
AKO-15750/15752
INPUT NO.
1
1
2
3
4
5
+
mA
AKO
80004A
PT100
Output:..............................................4-20 mA
Working temperature: .................-25 to +70ºC
Temperature range: ..................-100 to 350 ºC
10
B
A
A
B
AKO-D1472x / D1472x-C
1
2
3
4
+
mA
AKO
80004A
PT100
C
5
6
Publicidad
