YATO YT-85175 Manual De Instrucciones página 14

GB
the batteries and then administer aid to injured persons. Rectify the cause of the malfunction
or accident. Check the condition of the machine for damage before resuming operation.
Always disconnect the power supply by disconnecting the batteries: when the user leaves
the machine; before removing the jam; before inspecting, cleaning, or works on the machine;
after the machine has hit an object to check for damage; if the machine starts to vibrate ab-
normally, for an immediate check.
If the machine starts to vibrate excessively after start-up or during operation, this means
that the machine is not operating correctly. In this case, turn the machine off immediately,
disconnect the batteries and check it. Check the nozzle for any obstructions in the air inlet
and outlet. Once the obstruction has been removed, reassemble the machine, connect it to
the power source, and restart it. If excessive vibration persists, immediately turn the machine
off with the power switch, disconnect the batteries and hand it over to an authorised service
centre.
Although precautions have been taken during the machine's engineering and design and
considering that the guidelines in this manual have been followed, there is still a residual risk
in terms of exposure to vibration and noise. Therefore, use personal protective equipment.
Do not work too long, and take regular breaks.
Make sure that the batteries have been disconnected from the machine before carrying out
its maintenance.
Keep the machine out of reach of unauthorised persons, especially children. Make sure that
the machine is out of the reach of unauthorised persons, especially children, also during
operation.
PRODUCT OPERATION
Preparing for operation
Unpack the product by removing all packaging components. It is recommended not to dispose of the packaging as it may be useful
for later storage of the product.
Check all parts of the product for damage. Check the nozzle and the collection bag for any obstructions in the air inlet and outlet.
The product can be assembled for use in a blower or vacuum mode.
Warning! Make sure that the product is turned off during assembly i.e. the power switch is in the off position, and the batteries
are not connected to the machine's socket.
Product assembly
Fix the nozzle onto the air outlet.
The nozzle is equipped with latches, which should fi t into the holes on the nozzle (II). Secure the connection with a screw (II).
Set the front handle in the position that will ensure the greatest comfort of use. To change the handle position, simultaneously
press and hold both lock buttons in the handle base (III). Then turn the handle to the desired position and release the lock buttons.
Make sure that the handle is locked in a chosen position.
Preparing for operation — blower
Move the operating mode selection lever to the bottom position so that it is next to the symbol showing the direction of air fl ow —
blowing (IV). Make sure that the collection bag is not fi xed to the blower.
The product is ready for use as a blower.
Preparing for operation — vacuum
Move the operating mode selection lever to the upper position so that it is next to the symbol showing the direction of air fl ow —
suction (V). Fix the collection bag by sliding its fl ange on the air outlet so that the latch locks the collection bag fl ange (VI). The
fl ange can only be removed by pressing and holding the lock button and then sliding the fl ange from the air outlet (VI). There is a
band with an eye in the front part of the collection bag, which should be fastened on the hook located at the bottom of the nozzle
(VII). Such an installation will provide two attachment points for the collection bag and allow its capacity to be fully utilised.
The collection bag at the bottom has a closure. It allows easy emptying of the bag. Make sure that the collection bag is completely
O R I G I N A L I N S T R U C T I O N S
14