Publicidad
Programing The Remote Control
There are two ways to program the remote control ;
Using Automatic Code Search
1. Turn on the component you want to control (TV, AUX or DVD).
2.
Press and hold the component key you want to program.
until the LED on the remote control turns on,
3. Point the remote at the component, press and release the UP ( ▲ ) button, then wait three
seconds or until the
LED
stops
flashing. At this point the remote control
the
correct code to program. If, after three seconds, the component you want to control does
not turn off, press and releaseUP ( ▲ ) button again
codes.
4.
If the component you want to control does turn off; Press and release OK button , then the
blinks
three times.
Using Direct Entry Method
1.
Turn on the component you want to control (TV, AUX or DVD)
2.
Locate the enclosed Code List.
Find your brand of the component you want to control.
3.
Press and hold the component key you want to program. Holding the component key
until the LED on the remote control turns on,
4.
Enter 3-digit code from the code list, then the LED blinks three times.
5.
If you get no response, repeat these
steps using the next code listed for your brand
until the component responds to the remote control command.
Changing Volume Lock
Locking the volume controls to a single device makes it easier to control volume, without having to
guess whether the volume will change. If you lock the remote's volume controls to the TV , you will
always be able to change the volume to the level you want, without having to adjust it on multiple
devices.
If you want to lock the volume for the STB component ;
1.
Press and hold the STB component key until the LED on the remote control turns on.
2.
Enter 3-digit code, 9 9 9 .
3.Press and release the STB component key, then the LED blinks three times.
Unlocking volume control ;
If you want to unlock the volume for the STB component ;
1.
Press and hold the STB component key until the LED on the remote control turns on.
2.
Enter 3-digit code, 9 9 9 .
3.
Press and release the STB component key, then the LED blinks three times.
STB Power Macro
It realize users to switch on/off both STB & TV simultaneously, to relieve extra efforts
with adjusting device key on the RCU.
If you want to lock the power macro function ;
1.
Press and hold the STB component key until the LED on the remote control turns on.
2.
Enter 3-digit code, 8 8 8 .
3.Press and release the STB component key, then the LED blinks three times.
Unlocking power macro function ;
If you want to unlock the power macro function ;
1.
Press and hold the STB component key until the LED on the remote control turns on.
2.
Enter 3-digit code, 8 8 8 .
39
3.
Press and release the STB component key, then the LED blinks three times.
Automatic Code Search or Direct Entry
Holding the component key
then release the key.
is
searching for
to tell the remote to search the next set of
LED
then release the key.
40
Publicidad
