Publicidad
Idiomas disponibles
Idiomas disponibles
d
isassembling safety guard
Remove tension nut and backing flange.
Unscrew the safety guard until the grooves on both sides
meet each other. Remove the safety guard. Assamblage
in reverse order.
3.1.2 A
dditionAl hAndle
The additional handle must be screwed in at the left or
right, or in the gearbox head at the top.
3.2 t
ools
Use only clean tools!
3.2.1 c
/f
hAnging
itting the tool
Clean backing flange, clamping nut and backing
flange surface of the tool.
Place backing flange on the spindle with the longitudinal
groove down.
Fit the tool. The raised centering rim of the backing flange
must engage exactly in the bore of the tool.
Tighten down clamping nut with two-hole nut drive.
The wheels must run true. Do not use tools which
have gotten out of round. Trial run! Check tools
before use. The tool must be correctly mounted
and must rotate freely. Perform a trial run a minimum over
a period of 30 seconds without load. Do not used tools
which are damaged, which do not run true or which vi-
brate!
17
Publicidad
