Kärcher B 40 C Ep Manual De Instrucciones página 16

DANGER
Risk of injury!
First remove the mains plug before doing
any job on the device
 Drain and dispose of the dirt water and
the residual fresh water.
In case of faults that cannot be remedied
using the table below please contact the
customer service.
Fault Remedy
Appliance cannot be Insert the mains plug into a socket.
started
Check power supply of the socket.
Insufficient water quan- Check fresh water level, refill tank if necessary.
tity
Increase the water volume on the regulating knob for water volume.
Unscrew the lock of the fresh water reservoir. Remove and clean the fresh water filter. Insert the filter and screw
in the lock.
Remove the water distribution strip from the cleaning head and clean water canal (only R cleaning head).
Check hoses for blockages; clean if required.
Insufficient vacuum per- Clean the seals between waste water tank and cover and check for tightness, replace if required.
formance
Wastewater reservoir is full; shut off the appliance and empty the wastewater reservoir
Clean the fluff filter.
Clean the vacuum lips on the vacuum bar, replace if required
Check suction hose for blockages; clean if required.
Check the suction hose for tightness; replace if required.
Check if the cover on the dirt water discharge hose is closed
Check the setting of the vacuum bar.
Insufficient cleaning re- Check the brushes for wear, replace if required.
sult
Brushes do not turn Check if foreign matters block the brushes; remove foreign matter if required.
Reset fuse of brush drive.
Vibrations during clean- You might need to use softer brushes.
ing
16
Faults
6
-
EN