Publicidad
Idiomas disponibles
Idiomas disponibles
Installing & removing the battery pack
NOTE
:
This machine will only run when 2
•
batteries are installed. It is recom-
mended to use the same two batter-
ies and charge the two batteries at
the same time.
When you use two batteries with
•
different power,the machine will
only run to the level of the lowest
charged battery
ASSEMBLY
Concentrator nozzle Installation( only
for WP591)
OPERATION
Starting & Stopping
The tool runs for a few
WARNING!
seconds after it has been
switched off.
Let the motor come to a complete stand-
still before setting the tool down.
Adjusting the blowing speed / air volume
with 3-speed switch
USER TIPS
10
-
Hold the blower tube approximately
8" above the ground when operating
the tool.Use a sweeping motion from
side to side.
-
After blowing the debris/leaves into a
pile, it is easy to dispose of the pile.
Caution!
- Do not blow hard objects such as
nails, bolts, or rocks.
- Do not operate the blower near
bystanders or pets.
- Use extra care when cleaning debris
from stairs or other tight areas.
- Wear safety goggles or other suit-
able eye protection, long pants, and
shoes.
Turbo button for power boosting
NOTE:
•
Turbo button for power boosting can
increase air flow significantly, and it
can be used for clearing heavy or wet
debris.
•
First switch on the blower and select
a speed control (speed I or II), then
depress the turbo button and hold it.
Release the Turbo button, the blower will
return to the previously selected speed.
40V Cordless Blower
See Fig.
B, C
.
See
Fig. D
See
Fig. E
See Fig.
F1, F2
See
Fig. G
FOR BATTERY TOOLS
The ambient temperature range for the use and stor-
age of tool and battery is 0 ℃-45 ℃ (32 ℉-113 ℉).
The recommended ambient temperature range for
the charging system during charging is 0 ℃-40 ℃
(32 ℉-104 ℉).
5. CLEANING THE TOOL
Clean the tool regularly.
WARNING! Keep your product dry. Under no
circumstances spray with water.
-
To clean the tool, use only mild soap and a damp
cloth.
-
Do not use any type of detergent, cleaner or
solvent which may contain chemicals that could
seriously damage the plastic.
-
Self lubricating bearings are used in your
product, therefore lubrication is not required.
EN
Publicidad
