ledscom LC-L-216 Instrucciones De Montaje página 5

1. Disconnect the building-side connecting
cable from the power supply and secure it
against being switched on again. To do
this, trip the corresponding circuit breaker
of the house installation.
2. Remove the mounting plate (1) by
loosening the nuts (2). Then carefully lay
the light on its side so that it cannot be
damaged.
3. Drill two holes in the mounting base and
place there if necessary. Dowel in. The
positioning of the holes should correspond
to those of the screw holes (3) on the
mounting plate. Make sure that the dowels
are flush with the substrate.
4. Guide the building-side connection cable
through the mounting plate and then fix the
mounting plate (1) to the mounting base
with the aid of two screws.
5. Connect the wires of the cable according
to "Figure 2".
6. Place the light back on the mounting
plate (1). Then tighten the nuts (2) again to
fix the light to the mounting plate.
7. Turn the two end pieces (4) of the lamp
counterclockwise to insert the bulbs. Then
hand-tighten the end pieces. The
installation is now complete.
Subject to technical changes
LEDs Com GmbH, Dohrweg 2a, D-41066 Mönchengladbach, www.leds-com.de, Tel. +49 (0) 2161 - 5 75 99 76
English
Figure 1
1: Mounting plate
2: Nuts
Figure 2
Wall lamp (LC-L-216) - Assembly instructions
3: Screw holes
4: End pieces
03/2023