DesignHouse 529867 Instrucciones De Montaje

TWIN HANDLE
LAUNDRY TUB
FAUCET
Model 529867
Your new Design House faucet will give you years of trouble free performance. Thank you for
choosing our product for your home. Please read all of these instructions carefully before
installing your new faucet.
Helpful tools to install this faucet:
basin wrench
Teflon tape
(2) crescent wrenches
IMPORTANT POINTS
When installing your new faucet, hand tighten the connector nuts, then use one wrench to
anchor the fitting and a second wrench to tighten the nut one additional turn. Connections that are
too tight will reduce the integrity of the system.
Wrap all threaded connections (except aerator thread in spout) with Teflon tape available from
your local hardware or plumbing supply store. Always wrap in a counter-clockwise direction.
If replacing an old faucet: Prior to installation, turn off the cold and hot water lines and open the
old faucet to release built up pressure. Then cut both water supply pipes taking care that the pipes
remain circular. Remove burrs or rough edges from cut ends with fine grit sandpaper.
SAFETY TIPS
ALWAYS protect your eyes with safety glasses when cutting supply lines.
Design House is a registered
brand of DHI Corp.
Mequon, WI 53092
1-800-558-8700
silicon sealer
flashlight
faucet supply tubes
INSTALLATION PROCEDURE
INSTALLATION MAY REQUIRE (2) SHUT-OFF VALVES OR (2) FITTINGS.
1. Shut off water supply. Plug sink drain with cloth to avoid losing small parts. Remove old faucet.
2
2. Plug spout into faucet body and tighten
nut.
3. Position faucet body on laundry tub and
tighten the holding screw.
4. Attach hot and cold water lines.
PARTS AND ASSEMBLIES
HOLDING
SCREW
MAINTENANCE
Your new Design House faucet is designed to give you years of trouble free performance. Keep it
looking new by cleaning it periodically with a soft cloth. Avoid abrasive cleaners, steel wool and harsh
chemicals that will dull the finish and void your warranty.
Brass finishes are polished, then protected with a lacquer coating to help prevent tarnishing. Clean
these surfaces only with a damp, soft cloth.
CONSUMER PROTECTION WARNING
Under the Safe Drinking Water Act, the U.S. Environmental Protection Agency restricts the
amount of lead used in brass and solder. Your new faucet is made in strict compliance with all
government standards. The materials used in the manufacture of this faucet are of industry
standard quality and are similar to other plumbing products having brass fittings.
To reduce the amount of lead in your drinking water, allow the water to run for a moment before
filling your glass and remember to always use cold water for drinking purposes.
3
COLD
4
HOT
SPOUT
O-RING
FAUCET BODY