Publicidad
Idiomas disponibles
Idiomas disponibles
T E I D E
T E I D E
SMART DRY ELECTRIC THERMAL EMITTER
1. PRESENTATION
Dear customer,
Thank you for choosing TEIDE electric thermal emitters, with their sophisticated design, state-of-
the-art electronics (touch keys) and high reliability (TRIAC), smart control for maximum efficiency
and high build quality. They comply with the Ecodesign Directive and are designed and made in
Spain.
The TEIDE thermal emitters of COINTRA, as well as all their materials and components, have
undergone rigorous quality control tests.
Before switching the emitter on, you must carefully read these instructions which will help you
to ensure correct operation of the device with maximum performance and complete satisfaction.
Keep them close by in case of any doubts.
2. LOCATION
The ideal place to locate the electric thermal emitter is as close as possible to the coldest wall in
the room.
It is not recommended to install the thermal emitter on external walls without any insulation, how-
ever, in this case, the section of wall behind the thermal emitter must be insulated.
In bathrooms, the electric thermal emitter must be installed outside the protective area, according
to the regulations in force (zone 3 in the picture).
Classification of the bathroom zones
Under no circumstances may the thermal emitter be located under an electrical outlet.
Choose the location of the thermal emitter following the minimum distances indicated below:
46
EN
A73023243
Publicidad
