Publicidad
Idiomas disponibles
Idiomas disponibles
14.7 Stopping brake
Your scooter has an automatic parking brake included in the electromechanical brake. The
scooter stops when the engine is in drive and the ignition is switched off or when the ignition
is switched on and the hand lever is in the neutral position. If the scooter is in free wheel mode
(the engine is disengaged), it is possible to use the manual stopping brake function by placing
the lever in the drive position.
14.8 Thermal protection
The controller on your scooter has a thermal restore safety system. An incorporated circuit
controls the controller and engine temperature. If the controller and the engine overheat, the
controller will remove power to allow the electrical components to cool down. Although your
scooter returns to normal speed when the temperature returns to safe levels, it is advisable
to wait five minutes before restarting the scooter, to allow complete cooling of all components.
15. TRANSPORT
• Disassemble or fold the seat and the handlebar as far as possible in the loading area of the
vehicle used for transport;
• The choice to disassemble or lower the seat and the handlebar depends on the size and shape
of the trunk of the vehicle used for transport.
• Do not lift the scooter using the plastic parts of the body or the handlebar. Breakage of these
parts is not covered by the warranty.
• Do not lift the rear compartment using the tyres or the wheels. The compartment could rotate
and cause injury or damage.
• IT IS advisable to use removable sheets or other types of covering to protect the scooter
during transport.
WARNING!
• If the scooter and its components are not correctly and safely stored, they could
move or be carried by the air and cause injury or damage;
• Do not sit on the scooter during transport. When transporting the scooter, ensure it
is firmly secured with an approved anchoring/attachment system.
16. CLEANING
16.1 Cleaning the tyres
Clean the tyres with normal kitchen detergents and a damp cloth. Do not use solvents on the
tyres. Solvents could damage or soften the tyre material.
16.2 Cleaning the body
• Clean the scooter body with a damp cloth. Do not wash the scooter with a hose. Dry with a soft
and clean cloth;
• Use cold water mixed with a specific soap to remove dirt;
• Clean by hand with a soft cloth.
16.3 Cleaning the seat
Clean with a delicate soap or detergent and a damp cloth. A detergent for vinyl can also be used.
23
Publicidad
