Descargar Imprimir esta página

Motorhead MH-03-C-B1-20V1H-1 Manual De Instrucciones página 4

Publicidad

Idiomas disponibles

Idiomas disponibles

20V ULTRA RAPIDCHARGE 1-Hour Quick Charger (MH-03-C-B1-20V1H-1)
PRODUCT DISPOSAL
When this product reaches the end of it's life or is disposed of for any other reason, it
must not be disposed of in household waste. In order to preserve natural resources, and to
minimise adverse environmental impact, please recycle or dispose of this product in an
environmentally friendly way. It should be taken to your local waste recycling centre
or other authorised collection and disposal facility.
If in doubt consult your local waste authority for information regarding available recycling
and / or disposal options.
SPECIFIC SAFETY INSTRUCTIONS
The product is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the product by a person
responsible for their safety.
Children should be supervised to ensure that they do not play with the product.
Warning! Read and understand all instructions. Failure to follow all instructions listed
below, may result in electric shock, fire and/or serious personal injury.
Before using battery charger, read all instructions and cautionary markings in this
manual, on battery charger, battery, and product using battery to prevent misuse of the
products and possible injury or damage.
CAUTION: To reduce the risk of electric shock or damage to the charger and battery,
charge only MH lithium-ion rechargeable batteries. Other types of batteries may burst,
causing personal injury or damage.
Do not use charger outdoors or expose to wet or damp conditions. Water entering
charger will increase the risk of electric shock.
Use of an attachment not recommended or sold by the battery charger manufacturer
may result in a risk of fire, electric shock, or injury to persons. Following this rule will
reduce the risk of electric shock, fire, or serious personal injury.
Before using the device check that the mains cableand mains plug are not damaged.
Do not use the device if it has su ered any heavy shock or jolting, or is damaged in any
other way.
Due to the heat generated during charging, the battery charger should not be operated
on a combustible surface/in an inflammable environment.
Do not cover the ventilating slits.
Never disassemble the device yourself.
Pull the plug of the battery charger out of the socket when it is not in use or when
cleaning it.
Only use extension cables that are approved and technically in perfect condition.
During operation provide su cient ventilation.
Malfunction during charging can be caused by storing and operating in places where the
temperature exceeds +40°C; this should be avoided. Battery charging in closed
cupboards, near heat sources (radiators, bright sunshine) etc., causes heat to accumulate
and can damage the device.
If the battery is not going to be used for a longer period, pull the battery o the battery
charger and pull out the mains plug.
Protect battery contact to avoid a short circuit caused by metallic object that can cause
a fire or explosion!
Only charge original recommended batteries.
6
20V ULTRA RAPIDCHARGE 1-Hour Quick Charger (MH-03-C-B1-20V1H-1)
• If the power cord is damaged, it must be replaced by an Authorised Service Center in
order to avoid a hazard.
CHARGING PROCEDURE
When charging a new NiCad and/or Li-Ion battery it should be fully discharged followed
by a full charge for the charging rate for the battery as stated in the product manual plus
30 minutes. This should then be followed by a full discharge and a further full charge
for the charging rate for the battery as stated in the product manual plus 30 minutes.
This procedure will condition the battery and equalise the cell voltages.
Following this procedure will ensure the optimum operation of the battery.
When repeatedly using the charger to charge a number of batteries always allow the
charger to cool down before charging another battery. It is recommended that the
cooling down period is not less than 30 to 45 minutes.
When charging a battery that has been discharged during heavy use allow the battery to
cool down before charging. It is recommended that the cooling down period is not less
than 30 to 45 minutes.
NOTE: If the charger does not charge the battery pack under normal circumstances, return
both the battery pack and charger to the nearest MH authorised service centre for electri-
cal check.
BATTERY CHARGING INDOORS
This charger is designed to be used indoors. We do not recommend that it is used inside
your home.
Ideally batteries should be charged on a bench in a workshop, garage or shed. If the
charging operation is to be carried out in your home the area must be well ventilated
and the charger must be placed on a non combustible surface ensuring that the ventilation
slots are not blocked. Never exceed the charging time except when "Conditioning" a
new battery, as this could damage the battery and charger.
WARNING!Mains voltage must correspond with the voltage specifications on the
device.
7

Publicidad

loading