Publicidad
Idiomas disponibles
Idiomas disponibles
Orient the ring adapters to the tube end as shown in the diagram below. With the ring flush to the tube
end, twist the ring so the leading point of the tube coil slides into the inner ring grooves. Twist enough
rotations for a solid connection and repeat for other tube end.
UNIT
WINDOW SLIDER
ADAPTER
ADAPTER
Insert the Unit Adapter of the Vent Tube assembly into the slots of each side of the air outlet and slide
down the Unit Adapter. The tube will slide in securely in place.
2
Based on the size of your window, adjust the size of the Window Slider.
If the width of the window is short use slider section "A" and cut to size, sections "A" and "B" for
mid-length or all three sections "A" and "B" and "C" for extra length if needed for vertical installations.
A
3
2
1
Underside
View
1
B
Assembly steps:
Start with slider section (A) and insert a T-screw
mount (1) through the underside hole (2) and
screw on locking knob (3) VERY LOOSELY.
Slide the assembled section (A) around the end
of section (B) with the T-screw sliding into the
center channel groove.
Repeat for section (C) if needed and adjust com-
pleted slider length to window measurement.
Tighten locking knobs to secure panel connection.
Topside View
C
B
(CLOCKWISE ROTATION)
A
5
STEP TWO:
Installing the
Vent Hose
Assembly to the
Unit
STEP THREE:
Preparing the
Adjustable
Window Slider
Publicidad
