MESTIC MEG-300 Manual De Instrucciones página 7

Installation
1. Carefully clean the pan and lid before using the appliance for the first time.
2. Install the device on a horizontal and stable work surface.
3. Make sure you have one outlet nearby so that the cable is neither stretched nor in a zone of passage.
4. Plug in the supplied thermostat.
5. Plug the power cord into the socket.
6. Turn the thermostat to the highest setting. The indicator light will now turn on.
7. Preheat for at least 5 minutes and wait until the temperature indicator light turns off, before placing any food onto
the grill.
8. Using a heat resistant layer between the device and a table is advised.
9. Place the device in a well-ventilated space
Use
1. Grease the pan with butter, margarine or cooking fat.
2. Select the desired temperature with the thermostat knob.
3. When cooking is finished, it is possible to keep the appliance warm. To do this, set the thermostat knob to the
thermostat function.
4. Use the glass lid where possible, to prevent smells from escaping and to reduce cooking time.
5. Note: The lid has a vent through which hot steam can escape. Be careful not to come into contact with the steam.
6. Never use sharp objects on the grill, this will damage the non-stick coating.
7. Once you have finished cooking, disconnect the plug from the wall socket and let the appliance open for it to cool
down.
Maintenance and cleaning
1. In any event, unplug and let the appliance cool down before cleaning.
2. Reminder: do not immerse the appliance in water or any other liquid. Do not place the appliance in the dishwasher.
3. Do not use tools or abrasive solutions that would damage the coating. You can use a wooden kitchen utensil or
paper towel to remove most of the dirt.
4. After each use, empty the fat collecting tray and clean it with warm water and soap.
5. Clean the pan with a slightly damp sponge, or equivalent, and a mild detergent.
6. Only clean the outside of the appliance with a damp cloth.
7. Allow the device to dry after cleaning. Do not connect it if it is not dry.
Recycling
This product bears the selective sorting symbol for waste electrical and electronic equipment This means
that this product must be handled pursuant to European Directive 2012/19/EU in order to be recycled or
dismantled to minimize its impact on the environment. For further information, please contact your local
or regional authorities. Electronic products not included in the selective sorting process are potentially
dangerous for the environment and human heath due to the presence of hazardous substances.
Declaration of conformity
Hereby Gimeg Nederland B.V. declares that the device MEG-300, applies all basic requirements and other relevant
regulations listed in the European directive for electromagnetic compatibility (2014/30/EU) and low voltage directive
(2014/35/EU). If you require a full declaration of conformity, you can contact the adress listed on the backside of this
manual.