Publicidad
Idiomas disponibles
Idiomas disponibles
Inserting the battery into the machine (Fig. B, F)
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
1. Insert the battery (9) into the base of the ma-
chine as shown in Fig. F.
2. Push the battery further forward until it clicks
into place.
Removing the battery from the machine (Fig. F)
1. Push the battery unlock button (10).
2. Pull the battery out of the machine like shown
in Fig. F.
Checking the battery charging status (Fig. G)
• To check the battery charge status, push the
button (11) on battery shortly.
• The battery has 3 lights indicating the charge
level, the more lights that burn, the more
charge the battery has left.
• When the lights are not burning it means the bat-
tery is empty and must be charged immediately.
Charging the battery with the charger (Fig. G)
1. Take the battery (9) from the machine.
2. Turn the battery (9) to upside down position and
slide it onto the charger (13) as shown in Fig. G.
3. Push the battery until it is fully pushed into the
slot.
4. Plug the charger plug into an electrical outlet and
wait for a while. The LED indicators on the charger
(13) will lighten up and show the charger status.
The charger has 2 LED indicators (14) which indi-
cate the status of the charging process:
Red LED Status
Green LED status
Off
Off
Off
On
On
Off
WWW.VONROC.COM
After the battery is fully charged remove the charg-
er plug from the outlet and remove the battery from
the charger.
4. OPERATION
This machine can have its power supplied by using
a battery (9) or by connecting the AC adapter (8). If
the battery and AC adapter are connected simulta-
neously the fan will be powered by the AC adapter
and the battery will not be charged.
Switching the machine on and off (Fig. A)
1. To switch the fan on, press the switch button
2. To switch the fan off, press the switch button
Wind speed adjustment (Fig. A)
The fan has 3 wind speed settings.
• Push the speed adjustment button (2) to switch
• If the fan is switched on it will always start at
Head position adjustment (Fig. A, B)
• The fan head (3) can be positioned in a variety
Charger status
No power
Hanging the jobsite fan (Fig. D, E)
Standby mode:
• The fan can be hung on the supplied hook (6),
- No battery is
inserted or,
• The fan can also be hung under a flat, horizon-
- Battery inserted
but charging has
finished
Battery charging in
progress
When the machine is not being used over a
longer period of time it is best to store the
battery in charged condition.
(1) and hold it for 2 seconds.
(1) and the fan stops immediately.
between the 3 speed settings. The wind speed
increases when pressing the button and will
return to the lowest setting when running at the
highest speed.
the lowest speed setting.
of positions, 360° all around. To adjust the fan
head loosen the adjustment knobs (5) and posi-
tion the fan head (3) in the desired position, and
fasten the adjustment knobs (5) subsequently.
then place the fan head (5) in the desired position.
tal surface. The metal base (4) should be hung
upside down on a horizontal surface. Make sure
the 3 rubber feet do rest stable on the surface.
EN
7
Publicidad
