Publicidad
Idiomas disponibles
Idiomas disponibles
Inflating the product
1. Remove the product from the packaging and
spread it out in the location where you later
want it set up.
2. First inflate the bottom chamber, close the
safety valve (1), and push it in using light
pressure (Fig. A).
• Inflate with standard foot pumps or double
cylinder piston pumps with the appropriate
pump adapters.
• Do not inflate with a compressor or com-
pressed air bottle. Doing so may damage
the product.
3. Inflate the other two chambers.
Note: Be careful not to inflate the
chambers too firmly, as the seams may
otherwise overexpand or even tear.
Filling the product
Slowly fill the product no higher than the mar-
king (2) (Fig. B).
Note: Do not leave the product unatten-
ded whilst filling!
Draining the product
Open the safety valves and push in one side of
the product to allow water to drain.
Note: Please observe the local ordi-
nances for specific regulations on the
disposal of pool water.
Repair
Small leaks or holes can be repaired with the
included repair patch.
Important! Do not inflate the product
for 20 minutes after repairing!
Do not use the patches for leaks or
holes in the seam.
• Allow all air to discharge from the product.
• Thoroughly clean the area around the leak!
The area must be dry and free from grease.
• Cut out a piece of repair material large
enough for the edges to reach about 1.3cm
beyond the damaged area.
• Remove the patch from the paper, apply to
the damaged area and press on firmly.
Care, storage
Change the water in the product frequently,
particularly in hot weather and when dirty!
Always store the product dry, clean and deflated
in a temperate room. Always keep the valves
closed during storage. Only clean with water or
soapy water, never use harsh care products.
Disposal
Please dispose of the product and packaging in
an environmentally friendly manner, separating
different materials for recycling as required!
Dispose of this item through an authorised
disposal company or through your local waste
disposal facilities ‒ ask your local authority for
information if further guidance is required.
Ensure that you comply with all regulations
currently in force.
IAN: 21583
Service Great Britain
Tel.:
0871 5000 720
(£ 0.10/Min.)
E-Mail: deltasport@lidl.co.uk
Service Malta
Tel.:
80062230
E-Mail: deltasport@lidl.com.mt
You can also find spare parts for your product at:
www.delta-sport.com, category Service - Lidl Spare Parts
Service
GB/MT
11
Publicidad
