Audizio 102.300 Manual De Instrucciones página 7

CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must
be returned, it is important that the product is returned in the original factory box and packaging. If the device has been
exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising
condensation water might damage your device. Leave the device switched off until it has reached room temperature.
The label on the back/under side of the product indicates the mains voltage to which it must be connected. Check that the
mains voltage corresponds to this. Any other voltage than the one indicated may cause irreparable damage to the unit. The
unit must also be connected directly to the mains voltage and no dimmer or adjustable power supply may be used.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
1. Power
On/standby
2. LCD display
3. Previous
Press to select the previous track in BT and
USB modes
Press and hold to rewind
4. Eject
Press to eject the inserted CD
5. Next
Press to skip to the next track in BT and
USB modes
Press and hold to fast forward
6. Preset 1
Press and hold to save a station as preset 1
Press to recall the station saved in preset 1 slot
7. Preset 2 / stop
Press and hold to save a station as preset 2
Press to recall the station saved in preset 2 slot
Press during USB/BT playback to stop play
8. Preset 3 / play/pause
Press and hold to save a station as preset 3
Press to recall the station saved in preset 3 slot
Press during USB/BT playback to (re)start or pause play
9. Preset 4+
Press to open the preset list in FM and DAB modes
10. Source
Press to change modes
11. Menu / info
Press to cycle through station information
Press and hold to open the menu
12. Volume
Rotate to adjust the volume level
13. Headphone jack
3.5mm jack for inserting headphones
14. USB slot
15. Select
Rotate to select, press to confirm input
16. FM/DAB antenna
17. DC power adapter input
18. AUX input
3.5mm jack input for auxiliary play
• Remove the radio from the package box.
• Plug in the power adapter and press [Power].
Caution: Use only the adapter supplied with the radio. Connecting a power supply with a different rating can cause
permanent damage to the radio and may be hazardous.
Note: Make sure to fully extend the antenna (located at the back of the unit) to ensure the best possible FM and DAB
reception.
7