Publicidad
Start Up
Pilot Flame
1. Upon pressing and releasing the torch trigger, air will
start coming out without generating any arc.
2. Keep pressed the torch trigger without approaching it to
the work piece and a pilot flame will be started. This flame
is no capable of making an effective cut, however, it
prevents the material to disperse when tuning ON the
flame close to the piece.
3. Upon putting the torch near the work piece with the
pilot flame ON, automatically a plasma arc is generated
and you can start cutting.
General Considerations
• The cut shall always start in the work piece edge. Move
the torch in one direction only unless piercing is required.
CAUTION
• Always keep some space between the
nozzle and the work piece. Use the cutting guide (F). The
nozzle contact onto the work piece may cause the nozzle
gets stuck and interfere with the cutting movement,
getting a faulty cut.
• Keep the torch tip perpendicular to the work piece.
Observe and confirm the puddle moves along the cutting
line.
• Do not press the trigger intermittently. It damages the
torch components and the work piece.
CAUTION
• Every 4 or 8 hours check the moist
filter (G) and remove the excessive humidity. Too much
moist in the cutter or the torch may cause problems in
the operation.
ENGLISH
9
Publicidad
