Adjustment
Program the Travel
Travel limits regulate the points at which the door will stop when moving
up or down.
While programming, the UP and DOWN buttons can be used to move the
door as needed.
1.
Press and hold the Adjustment Button until the UP Button begins to
flash and/or a beep is heard.
2.
Press and hold the UP Button until the door is in the desired UP
position.
3.
Once the door is in the desired UP position press and release the
Adjustment Button. The operator will beep and the DOWN button will
flash.
4.
Press and hold the DOWN Button until the door is in the desired
DOWN position.
5.
Once the door is in the desired DOWN position press and release the
Adjustment Button. The operator will beep and the UP button will
flash.
6.
Press and release the UP Button. When the door travels to the
programmed UP position, the DOWN Button will begin to flash.
7.
Press and release the DOWN Button. The door will travel to the
programmed DOWN position. Programming is complete.
If you are unable to program the travel:
•
Ensure the cable tension monitor is correctly installed (refer to to
owner's manual).
•
Check to see if the safety reversing sensors are misaligned or
obstructed (refer to to owner's manual). When the sensors are aligned
and unobstructed, cycle the door through a complete up and down
cycle using the remote control or the UP and DOWN buttons. If you
are unable to operate the door up and down, repeat the steps above.
Programming Buttons
1
2
3
4
5
6
7
2
UP
Button
Adjustment
Without a properly installed safety reversal system, persons (particularly
Button
small children) could be SERIOUSLY INJURED or KILLED by a closing
door.
• Incorrect adjustment of door travel limits will interfere with proper
DOWN
Button
operation of safety reversal system.
• After ANY adjustments are made, the safety reversal system MUST
be tested. Door MUST reverse on contact with 1-1/2" high (3.8 cm)
object (or 2x4 laid flat) on floor.
To prevent damage to vehicles, be sure fully open door provides
adequate clearance.