Publicidad
Idiomas disponibles
Idiomas disponibles
HEATER button: Turns heater on and off.
NOTE: The heater only works when the flame
effect is on. If the flame effect is off, the heater
will not turn on.
NOTE: To prevent overheating, the heater fan
will blow cool air for 8-10 seconds before the
HEATER
heater turns on, and after the heater turns off.
When the heater is first turned on, a slight odor may be present. This is normal and should
NOTICE
not occur again unless the heater is not used for a long period of time.
To improve operation, aim the remote control at the front of the fireplace. DO NOT press the
NOTICE
buttons too quickly. Give the unit time to respond to each command.
Temperature Limiting Control
This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe temperature, the
heater will automatically turn OFF. To reset:
1. Unplug the power cord from the outlet.
2. Turn the ON/OFF switch on the TOUCH PANEL to OFF. Wait 5 minutes.
3. Inspect the fireplace to make sure no vents are blocked, or clogged with dust or lint. If they are, use a
vacuum to clean the vent areas.
4. With the POWER switch in the OFF position, plug the power cord back into the outlet.
5. If the problem continues, have your outlet and wiring inspected by a professional.
Remote Control Battery Information
Remote control uses two AAA batteries (Not Included)
NEVER dispose of batteries in fire. Failure to observe this precaution may result in an explosion.
Dispose of batteries at your local hazardous material processing center.
6. Care and Maintenance
Cleaning
ALWAYS turn the heater OFF and unplug the power cord from the outlet before cleaning,
performing maintenance, or moving this fireplace. Failure to do so could result in electric shock,
fire, or personal injury.
NEVER immerse in water or spray with water. Doing so could result in electric shock, fire, or
personal injury.
Metal:
Buff using a soft cloth, slightly dampened with a citrus oil-based product.
15
1. Press once. Indicator lights up.
Fan blows cool air for 10 seconds. 750W
heater turns on and blows warm air.
2. Press again. Indicator lights up.
1500W heater turns on and blows hot air.
3. Press again. Heaters turn off.
The fan blows cool air for 10 seconds to allow
heater to cool down, then turns off.
Publicidad
