Installing the wheels
the axle sleeve (M),
A
A
K
J
M
I
Installing the power cord storage
■ Line up the screw with the holes in power cord storage
and the upper handle.
■ Push the screw through and tighten it.
Installing the front panel and gun holder
■ Line up the screw sleeves with the holes in the upper handle
and push through.
■ Insert the screw and turn clockwise with a Phillips head
screwdriver (not included) until the screw is tight.
Installing the hose hook
■ Line up the hose hook upper end with the holes on the back
of the front panel
■ Insert the hose hook end into the hole and push through.
■ Press the hose hook lower end into the clip on the back of
the front panel.
upper end
hole
lower end
clip
Installing the upper handle
■ Push and hold the push-pin buttons on the sides of the upper
handle assembly as you slide the handle onto the frame.
Push-pin
Missing parts, accessories or need a service center?
Do Not Return to Store
Call : 1-866-915-9824
www.northerntool.com
This Quick Start Guide is not a substitute for reading the operator's manual. To reduce the risk
WARNING:
of injury or death, user must read and understand operator's manual before using this product.
2000 PSI / 1.2 GPM
ELECTRIC PRESSURE WASHER
PPW2000
Item# 106167
USING DETERGENT
■ Carefully pour pressure washer detergent in detergent tank.
■ Install blue or black soap nozzle.
■ Squeeze trigger and wait approx.1 minute for soap.
SPRAY TIP
SPRAY TIP APPLICATION
Green - Narrow fan tip (25° )
■ The green pressure washer tip provides high versatility with its 25 degree angle tip.
Referred to as the washing tip, because it provides adequate pressure to remove
dirt from surfaces, but is designed to not damage many surfaces. This pressure
O
25
washer tip is designed for "sweeping" foliage or debris given its wide angle. This tip
is versatile due to its wide area of cleaning and strong pressure application.
White - Wide fan tip (40° )
■ The white 40 degree tip, referred to as the "fan" tip creates the widest area of
cleaning with relatively low pressure. This pressure washer tip is best used for light
O
or delicate cleaning applications. It is recommended for light cleaning on wood
40
decks and other soft or delicate surfaces.
Black - Soap spray tip
■ The black soap spray tip, is used for soap application. Soap is applied under low
pressure high volume for optimum performance. Soap cannot be applied under
SOAP
high pressure with this machine.
Turbo Nozzle Tip
■ The nozzle rotates in a zero to 15 degree spray pattern in a circular motion to
break down tough dirt and grime. The spray pattern can cover area of 4 to 8 inches
wide, depending on a distance between the tip and the surface being cleaned.
1
Set-up
1
Connect garden hose to pressure
washer water intake.
2
Assemble pressure washer gun to spray wand.
3
Connect desired pressure tip.
4
Insert high pressure hose into trigger
handle.
5
Connect the high pressure hose to the
water outlet connector.
6
Turn on water at outlet.
7
Run water hose for 30 seconds with the
motor in OFF position. This helps drain air
from the hose and pump.
30
S
8
Connect power cord to wall outlet
Extension cord not recommended.
9
Turn on Pressure Washer
IMPORTANT: Ensure water outlet is On
before turning power On to avoid damage
to the pump.
NOTE:
AUTO ON/OFF SWITCH: This Pressure washer is equipped
with an Auto Start/Stop feature.
To operate: Turn the power switch to the On (I) position.
Pump will pressurize and shut down immediately.
Once the trigger of the gun is depressed the unit will turn on.
Unit will shut off and be in standby mode when trigger is
released.