Signature Design by Ashley 8530512 Instrucciones De Montaje página 5

WARNING:
If the chair is not functioning, check the plug in and connection of the cords first (The order is A-B-C), see the
Be sure cords are clear from the chair prior to operation.
HEAT AND MASSAGE FEATURE
Note : Your li� Chair may be ou�i�ed with a heat and massage feature. If so, follow the Addi�onal assembly and operaonal
instruc�ons below. Addi�onal connecons are required.
WARNING: It is important that you read and carefully follow all chair assembly instruc�ons. Do not plug the power
cord into an electrical outlet un�l all assembly has been properly completed. Failure to follow all chair assembly instrucons
may cause the chair to operate improperly possibly resulng in the risk of personal injury or death.
HEAT AND MASSAGE FEATURE ASSEMBLY INSTRUCTIONS
1. Connect the Massage motor (E) from the Back to the Seat. See Figure E .
2. Connect the Heat pad (F) from the back to the seat. See Figure E .
How to use the Heat and Massage features
Warning: It is strongly recommended that you consulta medical professional before using the heat and massage
features to determine if using the features is right for you. You should turn off the heat and massage features when
leaving the chair.
How to Use the Massage Func�on
Press the INTENSITY + bu�on once to ac�ve the massage func�on.
Press the INTENSITY - bu�on to low intensity, then press - again to off massage.
Press the MASSAGE or
se�ng: WAVE, STEADY, or PULSE. Each se�ng is indicated by a COLORED LED light.
The massage func�on will automa�cally shut off a�er 30 minutes of con�nuous use.
SIGNATURE DESIGN BY ASHLEY
Clear area below chair before lowering to reduce risk of injury or death.
bu�on to go to the three available massage
E (MASSAGE) F (HEAT)
M1 M2 H1
Figure E
All Rights Reserved.
HEAT(ON/OF)
MASSAGE SETTINGS
INTENSITY SETTINGS
May. 2022 00330B
Figure A.
USB
HEAT
WAVE STDY PULSE
MASSAGE
INTENSITY
WARNING
Clear area below
chair before lowering
to reduce risk of
injury or death
Page 5 of 17